15
YES
110 2 220 2 330 2 440 2 0 10
YES
@X05@X08■ @X07■ @X03■ @X09■ @X0B■
-------------------------
For configuration of the page prompts and menus use CFG\PGMENUS.CFG.

Line 1: number of pages, duration of a page is determined by line 3
Line 2: YES to do logging. If the user is not logged on the log info is
	written to 'work\mxlog.<nodenr>' to accomodate the use of this ppe
	by the matrix.
Line 3: This line gives the tone frequencies for one page in the following
	way (frequencies range from 0-65535, where 0 is no sound and the delay
	is in clock ticks where 18 clicks is about one second):
	<freq> <delay> <freq> <delay> etc.
	Make sure the last freq is a 0 (no sound) or else the speaker will
	keep sounding.
Line 4: YES to not allow a user to page if the sysop paged indicator is on.
	Otherwise the user is allowed to page.
Line 5: Characters shown when paging. There can be as much
        characters in this line as there are (frequency, delay) pairs in line
        3. These characters are shown in sequence and can be used to create
        some nicelooking effect when paging. If there are more pairs in line
        3 then there are characters the characters are shown again from
        the beginning and so forth.
	Here are some examples of strings you could also try: ─ \ │ / ─


The page command uses pcboard.sys (which is assumed to be in the same dir
as pcboard.dat) to check if the page bell is on or off. It also checks the
paging times in pcboard.dat.
'graph\pgtext' contains all the prompts etc.