; UDS 2440
;
; JUMPER SETTINGS: There are two jumpers INSIDE the modem that should
;                  be checked.  These are for CTS and RTS flow control.
;                  These look something like:
;
;                   o o|     o o o
;                   o o|   FLO   CTS
;                   F R
;                   L T
;                   O S
;
;                  The pins above "RTS" should be jumpered and the right
;                  two by "CTS" should be covered.
;
; ONE TIME MODEM SETUP:  The first time you run TE/2, upon entering the
; program, type the following lines and press ENTER after each.  Then
; exit and restart TE/2.
;
;       AT&F
;       ATS7=60
;       AT&C1&D2&R&T5%N8%U3%V0%K1&W
;
; NOTES: Set ALL dialing directory entries to 9600 baud
;        Data compression is enabled via AT%K1

Baud          9600
Parity        N
WordLen       8
StopBits      1

XonXoff       BOTH
CtsRts        BOTH
MatchBaud     FALSE

ModemInitStrg ATZ^M
ModemDialStrg ATDT
ModemDialSufx ^M
ModemHangStrg ;
DTRHangup     TRUE

Connect       CONNECT,9600

NoConnect     NO_DIAL_TONE
NoConnect     NO_CARRIER
NoConnect     BUSY
NoConnect     VOICE