TITLE:      Advanced Gravis Tech Note #18
AREA:       GUS SETUP
DATE:       March 8, 1993    
KEY WORDS:  SETUP ULTRASND ULTRADIR BLASTER

SUBJECT: Manually Editing AUTOEXEC.BAT for UltraSound

If you are expierencing trouble with the UltraSound  SETUP you may
manually add the following lines to the beginning of your AUTOEXEC.BAT.
If you are running DOS V5.0 or later you may use the DOS editor called
EDIT.  The lines are:

	SET ULTRASND=220,1,1,12,7
	C:\ULTRASND\ULTRINIT.EXE
	SET ULTRADIR=C:\ULTRASND
	SET BLASTER=A220 I7 D1 T1

This will configure your UltraSound for its new recommended default
configuration.  This example assumes that your UltraSound software was
setup on your C drive in a directory called ULTRASND.  It is also
assumed that your base port address is set to 220.

After you have made these changes and rebooted your computer try
running some of the demos that came with your UltraSound card
including, FLIDEMO and MIDIDEMO.   If these demo's hang your computer
try changing the GF1 IRQ,  DMA and base port address of your UltraSound
as you have a conflict with another piece of hardware.

 If you are still expierencing problems please feel free to call our
technical support line at (604) 431-1807.  Or you may leave us EMail
at any of the following addresses:

	InterNET:       tech@gravis.com
    CompuServe:     71333,350 or GO PCVENB
	FidoNET:        1:153/978

SET ULTRASND=220,1,1,15,7
                              Other Possible Values Are     Recommended
    220     Base Address      210, 220, 230, 240, 250, 260  220 or 240
    1,1     DMA Channel 1     1, 3, 5, 6, 7                 1 or 3
    15      GF1 IRQ           2, 3, 5, 7, 11, 15            12 or 11
    7       MIDI/SBOS IRQ 7   2, 3, 5, 7                    5 or 7

C:\ULTRASND\ULTRINIT.EXE
    Does a hardware reset of the UltraSound board.  You may hear a
    POPPING sound when run.

SET ULTRADIR=C:\ULTRADIR
    Tells the UltraSound software where it may find MIDI patches.  This
    is used by various programs including SBOS, PlayMIDI, Patches etc...

SET BLASTER=A220 I7 D1 T1     REQUIRED FOR SoundBlaster/Adlib Emulation
    A220    Base Address         220 or 240 recommended
    I7      IRQ 7                Must be the same as your UltraSound
                                   MIDI IRQ
    D1      DMA Channel 1        NEVER CHANGE - MUST ALWAYS BE 1
    T1      Type of SoundBlaster NEVER CHANGE - MUST ALWAYS BE 1
            to emulate