AdapterId	06e6ch

AdapterName	"M-ACPA/A"

NumBytes	1

NamedItem	Prompt	"Address Selection"

choice	"FDC0-FDC7"	pos[0]=xxxxx001b	io 0fdc0h-0fdc7h
choice	"FDC8-FDCF"	pos[0]=xxxxx011b	io 0fdc8h-0fdcfh
choice	"FDD0-FDD7"	pos[0]=xxxxx101b	io 0fdd0h-0fdd7h
choice	"FDD8-FDDF"	pos[0]=xxxxx111b	io 0fdd8h-0fddfh
choice	"Disable"	pos[0]=xxxxxxx0b

Help
"The base address of the M-ACPA/A can be at one of 4 different
locations. Choose a location which does not conflict with any
other installed board.  'Disable' will cause the M-ACPA/A to 
not be available.  This assignment need only be changed if it
is in conflict with another board.  Conflicting assignments
are marked with an asterisk.  Use the F5=Previous and the 
F6=Next keys to change address selection when you are in the
'Change configuration' window."


NamedItem	Prompt	"Interrupt Selection"

choice	"Interrupt 3"	pos[0]=xx000xxxb	int 3
choice	"Interrupt 4"	pos[0]=xx001xxxb	int 4
choice	"Interrupt 5"	pos[0]=xx010xxxb	int 5
choice	"Interrupt 6"	pos[0]=xx011xxxb	int 6
choice	"Interrupt 9"	pos[0]=xx100xxxb	int 9
choice	"Interrupt 10"	pos[0]=xx101xxxb	int 10
choice	"Interrupt 11"	pos[0]=xx110xxxb	int 11
choice	"Interrupt 12"	pos[0]=xx111xxxb	int 12
			
Help
"The interupt select chooses which interrupt level the M-ACPA/A
will use for interrupts.  Minimize the amount of interrupt
sharing by assigning other installed boards to different levels.
Conflicting assignments are marked with an asterisk.  Use the
F5=Previous and the F6=Next keys to change the interrupt level
selection if you are in the 'Change configuration' window."