STANDARD MICROSYSTEMS CORPORATION

                Wollongong PathWay Access v2.0 for DOS
                       For Ethernet LAN Adapters

                          INSTALLATION GUIDE

   This software is licensed by SMC for use by its customers only.
        Copyright (c) 1994 Standard Microsystems Corporation.
                         All rights reserved.


This installation guide describes:

o  How to use EZStart to copy the Wollongong PathWay Access 
   version 2.0 for DOS NDIS driver files from the SuperDisk 
   to your PC.

o  How to prepare your PC's operating system so you can attach 
   to the network.

Note: This driver supports all 8216 (Ultra), 80xx (Elite), 
      80xx (PLUS), and 8416 (EtherEZ) Series ISA, EISA, and Micro
      Channel Ethernet adapters.


COPYING THE DRIVER FILES

From the Driver Installation screen, select 'Copy Files' to copy all 
the files used by this driver from the SuperDisk to the Destination 
Directory recommended by EZStart, or to a different directory that you 
specify.


PREPARING YOUR OPERATING SYSTEM

Use the following steps to install the SMC8000 driver to support 
PathWay only:

1. Using any text editor, add the following three lines to your 
   CONFIG.SYS file:

          device=c:\pathway\pwtcp.sys
          device=c:\pathway\protman.exe/i:\<directory path>
          device=c:\lanman\SMC8000.dos

   In the above lines, "/i:\<directory path>" is optional and 
   specifies any valid directory containing PROTOCOL.INI (the 
   default directory is \LANMAN).

2. Create a PROTOCOL.INI file that contains the following lines:

        [Protocol Manager]
               DriverName = protman$

        [SMC8000-NIF]
               Drivename = SMC8000$

3. In your AUTOEXEC.BAT file, verify that you have a line similar
   to the following:

        NDIS -d:2

   In the above line, the number "2" indicates that the [SMC8000-NIF]
   section in the PROTOCOL.INI file is the second entry. If it was
   the first entry, the above line would read:

        NDIS -D"1

4. Proceed with the rest of the instructions in the Wollongong
   PathWay Installation Guide.


This commercial computer software and documentation is provided with
RESTRICTED RIGHTS.  Use, duplication, or disclosure by the
Government is subject to restrictions set forth in subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer Software
clause at DFARS 252.227-7013, or subparagraphs (c) (1) and (2) of the
Commercial Computer Software -- Restricted Rights clause at
FAR 52.227-19, or Alternate III of the Rights in Data -- General
clause at FAR 52.227-14, as applicable.  The manufacturer /
subcontractor is Standard Microsystems Corporation,   80 Arkay Drive,
Hauppauge,  NY    11788. 


SMC and Standard Microsystems are registered trademarks; and EtherEZ,
EtherCard Elite 16 Ultra, EtherCard Elite 16T Ultra, EtherCard Elite
16C Ultra, EliteSeries, EZStart, and SuperDisk are trademarks of 
Standard Microsystems Corporation.  Other product and company names 
are registered trademarks or trademarks of their respective holders.