STANDARD MICROSYSTEMS CORPORATION

                        FTP PC/TCP v2.2 for DOS
                       For Ethernet LAN Adapters

                           INSTALLATION GUIDE

    This software is licensed by SMC for use by its customers only.
         Copyright (c) 1994 Standard Microsystems Corporation.
                          All rights reserved.


This installation guide describes:

o  How to use EZStart to copy the FTP PC/TCP version 2.2 for 
   DOS NDIS driver files from the SuperDisk to your PC.

o  How to prepare your PC's operating system so you can attach 
   to the network.

Note: This driver supports all 8216 (Ultra), 80xx (Elite), 
      80xx (PLUS), and 8416 (EtherEZ) Series ISA, EISA, and Micro
      Channel Ethernet adapters.


COPYING THE DRIVER FILES

From the Driver Installation screen, select 'Copy Files' to copy all 
the files used by this driver from the SuperDisk to the Destination 
Directory recommended by EZStart, or to a different directory that 
you specify.


PREPARING YOUR OPERATING SYSTEM

1. Refer to Chapter 5 of the PC/TCP 2.2 Installation and 
   Configuration Guide, entitled "Using an NDIS Driver with the 
   Generic Kernel".

2. Copy the netbind files from the \NDIS subdirectory on FTP Disk A,
   labeled "Unsupported Network Software".

3. Using any text editor, add the following lines to your
   workstation's CONFIG.SYS file:

               device=c:\pctcp\protman.sys /i:c:\pctcp
               device=c:\pctcp\SMC8000.dos
               device=c:\pctcp\dis_pkt.gup

    Adjust the drive and path specifications to match your 
    installation.

4. Use any text editor to make the PROTOCOL.FTP file in the \PCTCP
   subdirectory on your PC's hard drive to look as follows:

    [Protocol Manager]:
         Drivername = potman$

    [SMC8000_NIF]
           Drivername = SMC8000$

    [PKTDRV]
           Drivername = pktdrv$
           Bindings = SMC8000_nif
           Intvec = 0x60
           Chainvec = 0x65

5. Rename the PROTOCOL.FTP file to PROTOCOL.INI. Refer to your DOS
   manual if you need assistance.

6. Proceed with the rest of the instructions in the PC/TCP 2.2 
   Installation and Configuration Guide.


This commercial computer software and documentation is provided with
RESTRICTED RIGHTS.  Use, duplication, or disclosure by the
Government is subject to restrictions set forth in subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer Software
clause at DFARS 252.227-7013, or subparagraphs (c) (1) and (2) of the
Commercial Computer Software -- Restricted Rights clause at
FAR 52.227-19, or Alternate III of the Rights in Data -- General
clause at FAR 52.227-14, as applicable.  The manufacturer /
subcontractor is Standard Microsystems Corporation,   80 Arkay Drive,
Hauppauge,  NY    11788. 


SMC and Standard Microsystems are registered trademarks; and EtherEZ,
EtherCard Elite 16 Ultra, EtherCard Elite 16T Ultra, EtherCard Elite
16C Ultra, EliteSeries, EZStart, and SuperDisk are trademarks of 
Standard Microsystems Corporation.  Other product and company names 
are registered trademarks or trademarks of their respective holders.