STANDARD MICROSYSTEMS CORPORATION

                             Banyan Vines
                       For Ethernet LAN Adapters

                          INSTALLATION GUIDE

   This software is licensed by SMC for use by its customers only.
        Copyright (c) 1994 Standard Microsystems Corporation.
                         All rights reserved.


This installation guide describes how to:

o  How to use EZStart to copy the Banyan Vines driver files from 
   the SuperDisk to your PC.
 
o  Prepare your PC's operating system so you can attach to the
   network.

Note: This driver supports all 8216 (Ultra), 80xx (Elite), 
      80xx (PLUS), and 8416 (EtherEZ) Series ISA, EISA, and Micro
      Channel Ethernet adapters.


COPYING THE DRIVER FILES

From the Driver Installation screen, select 'Copy Files' to copy all
the files used by this driver from the SuperDisk to the Destination 
Directory recommended by EZStart, or to a different directory that 
you specify.


PREPARING YOUR OPERATING SYSTEM

The following example shows how to create a boot diskette for a
Banyan client workstation that uses an SMC EtherEZ LAN adapter and 
SMC8000.DOS NDIS driver.

Note: You need to have an existing Banyan network operating
      system running to perform this task.

1. Create a DOS boot diskette.

2. Using any text editor, add the following lines to your 
   CONFIG.SYS file:

   DEVICE=A:\PROTMAN.DOS/I:A:\
   DEVICE=A:\SMC8000.DOS

3. Make sure that the SMC NDIS driver file (SMC8000.DOS) and the
   PROTOCOL.INI file are both copied to the boot diskette.

4. Run PCCOPY (a Vines utility) to copy the PC configuration 
   software and the LAN driver files from the VINES server to your
   boot diskette. Specify drive A as your Destination Directory
   when prompted by the operating system. Make sure to select
   NDIS Ethernet as your LAN driver option.

5. Run PCCONFIG (another VINES utility) from the boot diskette
   to configure your client PC for the network:
 
   o  Select "Network Card Settings". 

   o  Press the Enter key.

   o  Select "NDIS Ethernet".

   o  Press Enter.

   o  Enter the interrupt that the adapter is using. 

   o  Press Enter.

   o  On the "PROTOCOL.INI bindings =" line, type the entry name
      that matches the "Bindings=" statement in your PROTOCOL.INI
      file.
   
   o  Press Enter.

   o  Press F10 to save your configuration.

   o  Press Esc to exit the current screen.

6. Reboot your computer.


This commercial computer software and documentation is provided with
RESTRICTED RIGHTS.  Use, duplication, or disclosure by the
Government is subject to restrictions set forth in subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer Software
clause at DFARS 252.227-7013, or subparagraphs (c) (1) and (2) of the
Commercial Computer Software -- Restricted Rights clause at
FAR 52.227-19, or Alternate III of the Rights in Data -- General
clause at FAR 52.227-14, as applicable.  The manufacturer /
subcontractor is Standard Microsystems Corporation,   80 Arkay Drive,
Hauppauge,  NY    11788. 


SMC and Standard Microsystems are registered trademarks; and EtherEZ,
EtherCard Elite 16 Ultra, EtherCard Elite 16T Ultra, EtherCard Elite
16C Ultra, EliteSeries, EZStart, and SuperDisk are trademarks of 
Standard Microsystems Corporation.  Other product and company names 
are registered trademarks or trademarks of their respective holders.