Windows NT 3.5/3.51
Introduction:
-------------
This document describes the procedure to install Windows NT v3.5/3.51
driver for PCI I/O Mode Ethernet Adapter.
Location of Driver: \WINNT35\RTL8029.SYS
Installing driver procedure on Microsoft Windows NT :
-----------------------------------------------------
When you are in Windows NT :
1. In the Main group of NT, select the "Control Panel" icon.
2. In the Control Panel window, choose the "Network" icon.
3. In the Network Settings dialog box, choose the "Add Adapter" button.
The Add Network Adapter dialog box appears.
4. In the list of network cards, select "<other> Requires disk from
manufacturer", and then press <Enter> button.
5. Insert the network driver disk in drive A, enter drive and pathname
A:\WINNT35 which is the path where the driver RTL8029.SYS and
setup file OEMSETUP.INF are located, and then choose the OK button.
6. The screen will appear "Input EthernetID" dialog box which is provide
by RTL8029.SYS driver. This option is only required when you have
more than one adapter on this computer.
Select SKIP if only one adapter is installed on this computer.
7. "Bus Location" display in next screen. Your machine contains more
than one hardware bus, please select the Bus Type and Bus number on
which your network adapter card is installed.
8. NT will then perform the binding process. If any additional network
software options were installed, you may be prompted for specific
information for these packages.
9. Restarting your system you will acquire network service.
NOTES:
------
* Installing Multiple LAN Adapters:
Enter Windows NT and follow above setup procedure step 2,in the
"Network Settings" dialog box, choose the "Configure.." button.
The "Input Ethernet ID" dialog box appears and input adapter's
Ethernet ID. Last step to select OK and close NETWORK SETUP.
Select SKIP if only one adapter is installed on this computer.
