SCO UNIX

   Introduction:
   -------------
      This document describes the procedure to install the SCO UNIX driver
      for PCI I/O Mode Ethernet Adapter.

   Location of Driver:     \SCO\5X\DRIVER.O
   ------------------

   The following files will be used in this installation:
   ------------------------------------------------------

      driver.o    :  PCISCO MDI Driver Program
      setup       :  Transfer dos format to unix format setup program
      master      :  Used by netconfig
      system      :  Used by netconfig
      node        :  Used by netconfig
      space.c     :  Used by netconfig
      space.h     :  Used by netconfig
      lkcfg       :  Used by netconfig
      AOF/r2e     :  Used by netconfig


1.  Installation Diskette in DOS format.
    Put PCI I/O Mode PCI Ethernet Driver diskette to floppy A: and use doscp
    command to copy SCO UNIX Driver into UNIX's directories.

       # cd /
       # doscp A:/sco/5x/setup  /setup
       # chmod +x /setup
       # ./setup


2.     Use netconfig utility

       Available options:

       # netconfig

3.  To add adapters, select "Add New LAN adapter" from "Hardware".
    and select "PCI I/O Mode Ethernet Adapter Driver".

4.  Add Protocol to select SCO TCP/IP.

5.  Enter the internet Address of this interface       n.n.n.n

6.  Enter the netmask for this interface              (default 255.255.255.0)

7.  Enter the boardcast address for this interface     default: n.n.n.n

8.  Do you want to relink to kernel now ?               y

9.  Do you want this kernel to boot by default (y/n)    y

10. Do you want the kernel environment rebuilt (y/n)    y

11. Reboot unix.

        # shutdown -y -g0