Workstation for DOS ODI Client
------------------------------
Introduction:
-------------
This document describes the procedure to setup the NetWare DOS Requester
driver for 10/100 Auto PCI Ethernet Card.
Location of Driver: \DOSODI\ne100tx.COM
Sample Configuration Files:
---------------------------
STARTNET.BAT:
LSL
ne100tx
IPXODI
VLM
NET.CFG
;----------------------------------------------------------------------------
; Network Configuration File for NOVELL ne100tx.COM DOS ODI Client driver.
;----------------------------------------------------------------------------
Link Support
Protocol
Bind ne100tx
LINK DRIVER ne100tx
Frame Ethernet_802.2
Protocol IPX E0 Ethernet_802.2
Frame Ethernet_802.3
Protocol IPX 0 Ethernet_802.3
Frame Ethernet_II
Protocol IPX 8137 Ethernet_II
Frame Ethernet_snap
Protocol IPX 8137 Ethernet_snap
;Optional ne100tx driver keywords:
;--------------------------------
AUTOSENSE ;Performs Power-Up Autosense on all types of boards
; TP_FULL_DUPLEX ;selects twisted pair connection to work in
;full duplex mode.
; TP ;selects twisted pair connection to work in
;normal mode
; LINE_SPEED ;selects line speed between 10MBps and
100MBps on PCI Fast Ethernet Card.
NETWARE DOS REQUESTER
FIRST NETWORK DRIVE = F
Setup Procedures for Novell NetWare DOS Requester ( VLM) :
-----------------------------------------------
The installation utility INSTALL.EXE is located on NetWare's
"Workstation for DOS" disk. Run INSTALL.EXE from the Workstation
for DOS Disk.
The NetWare Client Install program screen will appear. You must
complete each of the questions. These options are specific to your
needs.
1. Enter the destination directory for the NetWare Client.
(The default directory is C:\NWCLIENT.)
2. Gives you the option to automatically update the CONFIG.SYS
and the AUTOEXEC.BAT files or modify them at a later time manually.
3. Do you wish to install support for MS Windows ? (Y/N)
(MS Windows Subdirectory: default C:\WINDOWS)
4. Asks you to select a network driver and provide configuration
options. It uses the specifications you select to create the
file NET.CFG. Insert the 10/100 Auto PCI Ethernet Card drivers
diskette when prompted for the driver diskette and specify the
driver path
A:\
5. Press <Enter> to install
NOTE:
-----
1. Be sure to add LASTDRIVE=Z to your CONFIG.SYS file for the
network mappings to work properly.
Parameters
----------
The following parameters can be used in order to control part of
the driver's operation.
These parameters are added to the driver's entry in NET.CFG
For NetWare standard parameters, please refer to NetWare user's
manual.
AUTOSENSE enables autosensing of media type when driver
is loading (Also called Power-Up Autosense) on
all types of supported adapter modes
TP_FULL_DUPLEX selects twisted pair connection to work in
full duplex mode.
TP selects twisted pair connection to work in
normal mode.
LINE_SPEED selects line speed between 10MBps and
100MBps on 10/100 Auto PCI Fast Ethernet
Adapter.
Format: LINE_SPEED <value>
Allowed values are: 10,100
NOTE:
-----
Driver selected connection is a combination of Line_Speed selection
and Media type selection(ether TP or TP_FULL_DUPLEX).
----------------------------------[ END ]-------------------------------------
