NDC Instant-Link Ethernet PCI Adapter
SCO_UNIX 3.x, 4.x Driver Installation
=====================================================

INSTALLATION PROCDURE

1)   copy the driver package to SCO_UNIX.
     -- make a new directory to save the PCI driver package
        and change to it.
            eg.  # mkdir pci
                 # cd pci
     -- use the system administration shell to copy package.
            # sysadmsh
     -- select Dirs/Files.
     -- select UseDos.
     -- select Copy.
     -- input the source file as 'a:/sco/sco_ndc.z'
        and input the destination file as 'sco_ndc.Z'

2)   uncompress the file.
        # uncompress sco_ndc.Z

3)   extract the file.
        # tar -xvf sco_ndc

4)   move the file 'sco_ndc' to any directory or remove it.

5)   insert a formatted disk to drive a:

6)   copy the extracted package to drive a:
        # tar -cvf /dev/rfd0135ds18 .

     (assume the drive a: is /dev/rfd0135ds18, check your system)

7)   use the 'custom' utility to install the package to SCO_UNIX.
        # custom

8)   use 'netconfig' utility to configure the PCI adapter to your system.
        # netconfig

Note : If you have any problem in using the 'custom' and 'netconfig'
       utility, you can refer to SCO_UNIX manual.


NDC Instant-Link Ethernet PCI Adapter
SCO OpenServer Driver Installation
====================================

INSTALLATION PROCDURE

1)   copy the driver package to your SCO OpenServer.
     -- make a new directory to save the PCI driver package
        and change to it.
            eg.  # mkdir pci
                 # cd pci

     -- use the "doscp" command to copy package.
            eg.  # doscp a:\sco\sco_ndc.z /pci/sco_ndc.dd.Z

2)   uncompress the file.

        # uncompress sco_ndc.dd.Z

3)   Insert a formatted diskette into floppy, use "dd" command to create
     a installation diskette for use.

        # dd if=sco_ndc.dd of=/dev/rfd0135ds18

     (assume the drive a: is /dev/rfd0135ds18, check your system)


4)   use the 'custom' utility to install the package to SCO_UNIX.
        # custom

     4-1). Select "Software" from menu bar.

     4-2). Remove the previous driver by selecting "Remove Software".
           (You do not have to re-build lernel at this time)

     4-3). Select "Install new" from "Software" menu.

     4-4). Follow instructions on screen, then system will install
           "ND5200S PCI Ethernet Adapter's LLI driver(ver 00.07)".

     4-5). Exit the "custom" utility.

5)   use 'netconfig' utility to configure the PCI adapter to your system.
        # netconfig

     5-1). Select "Add new LAN adapter" from "Hardware" meun bar.

     5-2). Select "ND5200S PCI Ethnernet Adapter, board 0" from list.

     5-3). Follow the instructions on screen to re-bulid the kernel.

     5-4). Reboot your system.

Note : If you have any problem in using the 'custom' and 'netconfig'
       utility, you can refer to SCO_UNIX manual page.