NDC Instant-Link Ethernet PCI Adapter
Packet Driver for NCSA PC/TCP Installation
=================================================

INSTALLATION PROCEDURE

1)   Make sure you have the correct version of NCSA Telnet for the
     PC.  You need version 2.3 or later to support the packet
     driver interface.

2)   Install the NCSA software onto your system.  Please refer to
     the NCSA documentation for detailed instructions.

3)   Load the ND5200 Packet Driver "ND5200PK.COM" in the \PCTCP
     directory of Setup diskette:

     ND5200 Packet Driver Basic Syntax:

          ND5200PK <packet_int_no>

     where:

     <packet_int_no>  This specifies the software interrupt (IRQ)
                      where you'll load the packet driver.  It must
                      be in the range 0x60 to 0x80.

                      The PC/TCP kernel, by default, is loaded at
                      interrupt 0x61 (so don't load the packet
                      driver there!)

     Following is an example to load the ND5200 packet driver using
     software interrupt vector 0x60 for ND5200 Ethernet adapter.

          ND5200PK 0x60

4)   At this point you are ready to run NCSA applications (e.g.,
     'ftp', 'telnet', etc.).

     For information regarding NCSA's products please contact:

     National Center for Supercomputing Applications
     264 Computing Applications Building
     605 E. Springfield Ave.
     Champaign, Ill. 61820
     (217) 244-0638
     telbug@ncsa.uiuc.edu

------------------------------[ END ]--------------------------------