NDC Instant-Link Ethernet PCMCIA Adapter (ND51XX)
Packet Driver for NCSA PC/TCP Installation
=================================================

PRE-INSTALLATION

     Before installing the NOS or network applications, first run NDCONF1
     to configure and diagnose the Instant-Link adapter(s). We recommend
     you to select "Update CONFIG.SYS" in the "Configuration
     Menu" before exiting NDCONF1.


INSTALLATION PROCEDURE

1)   Make sure you have the correct version of NCSA Telnet for the
     PC.  You need version 2.3 or later to support the packet
     driver interface.

2)   Install the NCSA software onto your system.  Please refer to
     the NCSA documentation for detailed instructions.

3)   Load the NE2000 Packet Driver "NE2000PK.COM" in the \PACKET
     directory of Instant-Link Setup diskette:

     NE2000 Packet Driver Basic Syntax:

          NE2000PK <PD_INT_NO> [IRQ] [IO_BASE]

     where:

     <PD_INT_NO>    This specifies the software interrupt (IRQ)
                    where you'll load the packet driver.  It must
                    be in the range 0x60 to 0x80.

                    The PC/TCP kernel, by default, is loaded at
                    interrupt 0x61 (so don't load the packet
                    driver there!)

     [IRQ]          This specifies the hardware interrupt (IRQ) of
                    your card.

     [IO_BASE]      This specifies the I/O address of your card.

     Following is an example to load the NE2000 packet driver using
     software interrupt vector 0x60 for NE2000 compatible adapter
     with IRQ=3, IO_BASE=0x300.

          NE2000PK 0x60 3 0x300

4)   At this point you are ready to run NCSA applications (e.g.,
     'ftp', 'telnet', etc.).

     For information regarding NCSA's products please contact:

     National Center for Supercomputing Applications
     264 Computing Applications Building
     605 E. Springfield Ave.
     Champaign, Ill. 61820
     (217) 244-0638
     telbug@ncsa.uiuc.edu