Novell NetWare MultiProtocol Router 
===================================                         March 1995
                                                            ----------

To install and configure NetWare MultiProtocol Router version 2.1, and 
MultiProtocol Router Plus version 2.1 for use with  a  Madge  Ringnode 
(or  Straight  Blue  adapter),  read  the NetWare MultiProtocol Router 
Installation Guide in conjunction with the following instructions. 

If you are using source routing, you must install a  Madge  Bridgenode 
or  Straight  Blue adapter. Smart 16/4 Ringnodes do not support source 
routing for MultiProtocol Router.

1  Install your adapters  following  the  instructions  in  the  Madge 
   hardware installation guide.

2  Load NetWare's INSTALL.NLM utility.
   
3  Select Product Options from the "Installation Options" menu.
   
4  Press [Insert] and perform the interactive procedure for installing 
   MPR from a floppy disk. When installation is complete, exit the MPR 
   Install program.

5  Load NetWare's INETCFG.NLM utility. 
   
6  Select "LAN and WAN Board Parameters".
   
7  Select the MADGEODI driver for Smart 16/4 Ringnodes, or  the  TOKEN 
   driver  for  Straight  Blue  adapters. (If you want source routing, 
   plus access to the server on Multiprotocol Router version 2.1, load 
   the virtual driver VBRIDGE as well.) 
   
8  Select Add New Board.
   
9  Specify a logical name for the adapter.
   
10 In the parameters field,  enter  the  port  address  (AT  and  EISA 
   adapters) or slot number (Micro-Channel adapters).
       
11 For  frame  type select TOKEN-RING or TOKEN-RING_SNAP. Each logical 
   name supports one frame type. Create a new logical  name  for  each 
   frame type you require.
   
12 Enable  and configure the protocols you need. If you require source 
   routing, enable the  source  routing  option.  If  you  are  source 
   routing  between  three  or more interfaces, specify a virtual ring 
   number greater than zero.
   
13 Bind the protocols to the adapters.  If  you  have  enabled  source 
   routing, bind the Bridge protocol to each logical name. 
  
14 Configure  SNMP  information  if  you  intend  to  use  SNMP remote 
   management tools. 
     
15 Edit your AUTOEXEC.NCF file by deleting all existing adapter-driver 
   bindings,  and inserting the following lines: 
   
   LOAD LSLENH 
   LOAD SNMP 
   INITIALIZE SYSTEM
   
16 Your installation and configuration of NetWare MultiProtocol Router 
   or MultiProtocol Router Plus is now complete.
   
          ****************** End of MPR.INF ***************