ISA NE-Series Ethernet Adapter
NDIS DRIVER FOR WOLLONGONG AND PATHWAY ACCESS INSTALLATION
==========================================================
The drivers named ETHNE contained in the NDIS directory
NDIS conform to the Network Driver Interface Specification
(NDIS) defined by Microsoft/3Com.
NDIS Driver Installation on PATHWAY ACCESS
------------------------------------------
1. Insert your copy of the Pathway Drivers diskette
into drive A.
2. Install the Pathway Drivers into your PC hard disk
drive. Type the following, indicating the subdirectory
where you want to install the program. Then press
<Enter>.
A:\> pwinstal C:
The pwinstall program automatically installs the driver
software in a new directory named \PATHWAY in your
specified drive. Your system will prompt you with
the following message once the process is complete:
"The Pathway Drivers have been copied successfully.
Refer to the documentation to complete driver
installation."
3. Insert your Driver Diskette in drive A: and copy the
NDIS driver to the subdirectory where you want to
install the Pathway software. Do this by typing
the following command from DOS:
A:\> Copy A:\NDIS\DOS\ETHNE.DOS C:\PATHWAY
4. Edit the CONFIG.SYS file to contain the
following command lines:
DEVICE=C:\PATHWAY\PWTCP.SYS
DEVICE=C:\PATHWAY\PROTMAN.EXE/I:C:\PATHWAY
DEVICE=C:\PATHWAY\ETHNE.DOS
5. Edit your PROTOCOL.INI file in the C:\PATHWAY
subdirectory to include the following section:
[ndis2]
DriverName = ETHNE$
6. Edit your AUTOEXEC.BAT file to include the following
command lines:
path=c:\pathway
ndis [-d:#]
pwbind
where:
-d is an optional parameter used for accessing
a specific module number within the PROTOCOL.INI.
In your PROTOCOL.INI file, a line enclosed by
square brackets designates the beginning of a
new module. Each module is referred to by a
hexadecimal number. The first module is module
number one. The second module is module two, and so on.
---
All trademarks or brand names mentioned are properties of their
respective owners.
===End===
