7  FTP PACKET DRIVER FOR ICL ETHERTEAM16I


NOTE! The current version of the EtherTeam16i FTP Packet  Driver  is  a  beta
release.


7.1  Installation of the Driver


To  install  the  FTP Packet Driver, start it with the following command line
syntax :

   eth16i [options] <packet_int_no> [<io_addr> [<net_port>]]


The EtherTeam16i requires no additional parameters (the defaults are  fetched
from the SETUP EEPROM), but optionally the following can be defined:

 1. io_addr

    The  base  I/O  address,  either  any  valid address (must match with the
    Setup), or 0xFFFF corresponding to search mode (AUTO).

    In systems where only one EtherTeam16i is installed, it is not necesssary
    to  specify  the  I/O  Base  Address,  but   the   driver   searches   it
    automatically.


 2. net_port

    Network  connection (Transceiver), either any specific (0 = BNC, 1 = AUI,
    2 = TP) or detected (3 = AUTO).

    In AUTO mode the driver can detect the network  connection  automatically
    (provided that the cable is connected).