NWDOSODI.TXT file
3Com Corporation
Network Drivers Installation Notes

              WINDOWS 3.1X AND NOVELL NETWARE


This document describes how to configure the LAN+Modem card
for use with Windows version 3.1x and Novell NetWare. These
procedures are also described in the LAN+Modem card User
Guide.

NOTE: The following instructions assume you have not installed
      any other network adapter in the PC. If networking
      has already been installed, some of the instructions will
      not apply or appear accurate. Consult with your MIS 
      department for further instructions.

Before installing the network driver, you should know the 
transport used in the Novell Network (typically IPX/SPX) and
have access to the following software components:

    - Novell NetWare VLM Client disks for DOS and Windows
    - The EtherDisk diskette that came with your LAN+Modem card.

Installation Instructions
-------------------------

1.  Boot the PC in DOS. If the PC starts up in Windows,
    exit Windows to return to the DOS prompt. 

2.  Place the Novell VLM client disk #1 in the floppy drive. Type:

        a:\install <Enter>.

    This opens the NetWare client installation screen.

3.  Use the down arrow key to move from line to line. Ensure 
    that the information is correct. When you are asked to select
    the driver for your network card, press <Enter> to see the
    list of supported adapters. At the bottom of the list, find
    and select Other Drivers.

4.  When prompted for a driver disk, put the EtherDisk in your 
    floppy drive and press <Enter>. The LAN+Modem card should
    appear as the first item on the list. Select it and press <Enter>.

5.  Specify the frame type by pressing <Enter> and choosing the
    appropriate type from the list. Press <Enter> to select your
    choice. (You will not need to select an I/O Base. Use the
    default.)

6.  Press F10 to return to the main installation screen. Position
    the cursor on line 6 and press <Enter>. The installer
    prompts for several diskettes and notifies you when the
    installation is complete.

7.  Press <Enter> to exit the installation program and return to DOS.

8. Reboot the PC by hitting <CTRL><ALT><DEL>. When you 
    go into Windows You will be able to LOGIN to the 
    Novell Servers.

The configuration manager (3CELCM.EXE) must be added to the AUTOEXEC.BAT file or CONFIG.SYS file. Add the line:

     3celcm

Specify a directory path if required.

(%VER NWDOSODI.TXT v1.0a)