AdapterId 06042h


AdapterName "3Com EtherLink/MC Ethernet Adapter"


NumBytes 2


NamedItem

Prompt  "Enable/Disable Adapter"

Choice  " Adapter Enabled "    pos[0]=XXXXXXX1b
Choice  " Adapter Disabled "   pos[0]=XXXXXXX0b

Help

"This controls whether the adapter is enabled or not.
Use the Enabled setting for normal use.
Use the Disabled setting if you are not using
the adapter and enabling it causes a conflict
with another device."

NamedItem

Prompt "I/O Address Range"

choice "  300 to  307 " pos[0]=XXXXX00Xb  io 0300h-0307h
choice " 1300 to 1307 " pos[0]=XXXXX01Xb  io 1300h-1307h
choice " 2300 to 2307 " pos[0]=XXXXX10Xb  io 2300h-2307h
choice " 3300 to 3307 " pos[0]=XXXXX11Xb  io 3300h-3307h

Help

"Determines the range of i/o addresses used by EtherLink/MC.
The addresses in this range cannot be used by another
installed device."


NamedItem

Prompt "Interrupt Level"

choice " Channel 3 "  pos[1]=XXXX0100b  INT 3
choice " Channel 7 "  pos[1]=XXXX0010b  INT 7
choice " Channel 9 "  pos[1]=XXXX1000b  INT 9
choice " Channel 12 " pos[1]=XXXX0001b  INT 12

Help

"Determines the interrupt level used by EtherLink/MC.
This adapter's interrupt level can be shared with
another device.  You may be able to improve performance
by selecting a level that is not used by any other device."


NamedItem

Prompt "Packet Buffer RAM Address Range"

choice " 0C0000 to 0C5FFF "  pos[0]=XXX00XXXb  mem 0c0000h-0C5FFFh
choice " 0C8000 to 0CDFFF "  pos[0]=XXX01XXXb  mem 0c8000h-0CDFFFh
choice " 0D0000 to 0D5FFF "  pos[0]=XXX10XXXb  mem 0d0000h-0D5FFFh
choice " 0D8000 to 0DDFFF "  pos[0]=XXX11XXXb  mem 0d8000h-0DDFFFh

Help

"Determines the range of RAM and ROM addresses used by
EtherLink/MC.  The addresses in this range cannot be
used by any other installed device.  The range represents
16K bytes of RAM addresses followed by 8K bytes of ROM
addresses."


NamedItem

Prompt "Transceiver Type"

choice "On-Board Transceiver (BNC)"      pos[0]=XX0XXXXXb
choice "External Transceiver (DIX)"      pos[0]=XX1XXXXXb

Help

"Determines the type of transceiver connection used by
EtherLink/MC.  If you have a thin ethernet network and wish
to connect using T connector, select On-Board.  If you
have a drop cable from an external transceiver
and wish to attach to the adapter's 15 pin DIX connector,
select External."