╔════════════════════════════════════════════════════════════════2249S.asc═══╗ ║ M2247/48/49S/SA/SB Jumper Location SCSI Interface ║ ╠════════════════════════════════════════════════════════════════════════════╣ ║ Zylinder: 1243 Köpfe: 7/11/15 Single-ended SCSI ║ ║ Sektoren: 65 (256bytes/sector) M224xS Capacity Formatted: (512B/sec) ║ ║ 36 (512bytes/sector) M224xSA 153/244/333 (Mio Bytes) ║ ║ 19 (1024bytes/sector) M224xSB ║ ║ ║ ║ ┌──────────────────────────────────────────────────────────┐ ║ ║ Power- ░ 16┌──────┐2 │ ║ ║ connector ░ 15└CHN104┘1 │ ║ ║ ░ │ ║ ║ Pin 1 ▓ 16┌──────┐2 └┐ ║ ║ ▓ 16┌──────┐2 10┌──────┐2 15└CNH103┘1 │ ║ ║ ▓ 15└CNH105┘1 9└CNH106┘1 │ ║ ║ SCSI- ▓ 16┌──────┐2 │ ║ ║ connector ▓ 15└CNH101┘1 │ ║ ║ ▓ 16┌──────┐2 │ ║ ║ ▓──┐ 16┌──────┐2 15└CNH102┘1 │ ║ ║ Pin 50▓ C│ 15└─CN3──┘1 │ ║ ║ │ N│ └┐║ ║ │ 5│ │║ ║ └──┴─────────────────────────────────────────────────────────┘║ ║ ║ ║ * = Default setting (Werkseinstellung) S = Shorted ║ ║ ** = empfohlene Einstellung für IBM-komp. PC O = Open ║ ║ ║ ║ CN5 Switch Setting CN5 CN5 ║ ║ 1 2 3 SCSI ID 4 SCSI parity check 7 Syncronous Mode ║ ║ * OFF OFF OFF 0 OFF Not execute * OFF Permit ║ ║ ON OFF OFF 1 * ON Execute ** ON Inhibit ║ ║ OFF ON OFF 2 CN5 CN5 ║ ║ ON ON OFF 3 5 Arbitration 8 On line self diag ║ ║ OFF OFF ON 4 OFF Disable * OFF Stop (normal) ║ ║ ON OFF ON 5 * ON Enable ON Execute (diag.) ║ ║ OFF ON ON 6 ║ ║ ON ON ON 7 SW6 not used, default is OFF ║ ║ ║ ║ CN3 ║ ║ 11-12 13-14 SCSI Terminator power 15-16 Front Panel LED indic.║ ║ * S S From Termpwr Pin and IDD O Seek complete ║ ║ O S From IDD * S Seek complete and ║ ║ S O From Termpwr Pin SCSI accessing ║ ║ ║ ║ CN4 ║ ║ 9-10 Unit attention condition ║ ║ S Power on, Reset, Mode select paramter changed ║ ║ * O Not ready to ready, Reset, Mode select parameter changed ║ ║ ║ ║ CNH105 ║ ║ 11-12 13-14 Device typ 15-16 Spindle Motor after power on ║ ║ O O M2247S/SA/SB * S Rotate ║ ║ S O M2248S/SA/SB O Not rotate ║ ║ O S M2249S/SA/SB ║ ║ ║ ╚════════════════════════════════════════════════════════════════════════════╝