11/1/95 Courier V.Everything Release Notes - changes since 7/5/95 
=================================================================

New Features/Improvements

1.  V.34 leased line (&L1) mode supported.  If V.34 is disabled, 
    then leased-line mode works as it has in the past.

2.  Added S55 bit 7 to control Phase Roll Compensation.  This allows
    better connect rates when operating on lines with asymmetrical frequency 
    offset.  It is intended primarily for testing.

    Setting S55 bit 7 = 1 will enable Phase Roll Compensation, default is 
    disabled.   Note that this will _reduce_ performance if used on lines 
    that do not suffer from this type of impairment.

3.  Added 3 new fields to the ATI11 screen:  Near echo, Far echo, and
    Signal to Noise Ratio.

4.  Improved handling of inbound BREAK signal when Remote Access feature
    is enabled.

5.  Corrected V.34+ result codes when used with &A0.

========================================================================== 
Known Issues

1.  Modem may need to have dip switches configured as follows in order to
    flash to previous firmware:

Externals                   Internals

 1   ON                      1   ON
 5   ON                      5   ON
 7   ON
 8   OFF                     8   OFF
10   ON

Dip switches not listed can be set in either position.