This is a another release by Dante!

What is it? Extra protectio to any of your important commands (say the 9
            command for EXIT TO DOS)

Why use it? Keep all those pesky wanna be hackers from messing with your
            board and watch how it pisses them off!

Installation - Make a directory for the PPE. say C:\PCB\PPE\SECURE
               Copy the files into this directory. Then copy the .PPE file
               and the .CFG file to the name of the command you want to
               replace. If you wanted to replace the 9 command you would type
               COPY SECURE.PPE 9.PPE
               COPY SECURE.CFG 9.CFG
               That is no necessary but the only way to make it usable for more
               than one command. Then go into PCBSETUP and press
               B the B again and move down to the CMD.LST file and add
               (I am again using 9 as an example)

               9     SECLEVEL     C:\PCB\PPE\SECURE\9.PPE

               Then you are all set. If you want to use it for any other
               command just do the same but replace the 9 with the other
               command.

Configuration - Line 1: The password for the command MUST BE IN CAPS TO WORK!!!
                Line 2: The Command that is to be replaced
                Line 3: The string were it asks for the password to the command
                        place an _ (underscore) at the end of the line to
                        disable the ? at the end of the prompt/
                Line 4: The string that is displayed when a user misses the
                        password.