





                      жФФФФФП в  Т  жФП жФФФФФП жФФП жФвФП
                      К       гФФД  гФП К       К  Г К К Г
                      гФФФФФП гФФй гФФй К       гФФй а а С
                            Г           К
                      гФФФФФй           гФФФФФй

                        By: Kyle Keller A.K.A -=Killer=-
                                       Of
                             -=KILLER=- ProGramming


1.>DisClaimer
-----------------------------------------------------------------------------
    This file is FREEWARE. It maybe distributed freely as long as no changes
    have been made. I accept no responsility for any damage this may cause.
    (Don't worry it won't cause any) If you encounter a problem call my BBS
    or leave me a message in PCBNET a FIDONET confernece.
  
    These files are included:

    Sysops.ans- May modify to list of your own sysops
    Sysops.cfg- List of actual names used on board make sure there in the
    same order as Sysops.ans
    File_id.diz- Board Description of this file-Please put this on your board
    for d/l
    Syscom.ppe- File you add to cmd.lst
    Syscom.cfg- Configure to which message base you want comments to go..also
    what you want the message to be called.
    syscom.doc- Your reading this

    Any other files were added by other people. (MAYBE BBS ADS)

2.>IntroDuction
-----------------------------------------------------------------------------
    I started programming about a month ago (1/96) and this is my second PPE
    in release. My other was called -=KILLER's=- Pager. It is a Sysop Pager.
    I enjoy programming and am hoping to make plenty more PPE's. If you have
    ideas leave me a message at the conference listed in disclaimer. Well let's
    do the instalation now.

3.>Installation
-----------------------------------------------------------------------------
    1.) UNZIP if you already haven't SysCom.zip into any directory you wish.
    2.) Configure Syscom.cfg to what you wish. Line instructions are included.
    3.) Edit Sysops.cfg to list your sysops. Use the names that they use on the
    board. Make sure they are in the same order as in Sysops.ans
    4.) Use an ansi editor like THEDRAW to edit sysops.ans. List the sysops in
    the same order as in Sysops.cfg.
    5.)Run PCBSETUP from your dos prompt or PCB itself, and choose option B,
    then B again... edit your CMD.LST file and create a new line.. For the
    command key, choose C (the Sysop Comment Key), for the Security..
    choose whatever you want.., Leave 'Charges' and 'Per Use' as the are, for
    the PPE/MNU File Specification, put in the complete path and filename to
    Syscom.ppe
    For example: 
                               CHARGES  PER      PPE\MNU SUBSTITUTION -or-
   COMMAND       SECURITY     MINUTES    USE      COMMAND LINE SPECIFICATION 
--------------------------------------------------------------------------
1. C                   10          0       0    C:\PCB\syscom\syscom.PPE  

   6.) Thats it...you should now have a working commentor. If you didn't know
   in Syscom.cfg make sure the second line has 1-? however many sysops you have
   listed in sysops.cfg.

4.>Support
-----------------------------------------------------------------------------
If you have any problems you can leave me a message on my BBS. If I come out
with any new versions you can d/l them at my BBS also.

                       The Whipping Post- (609)582-3678
                          Sysops- Bob & Kyle Keller