컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴 Welcome Beta Testers! 컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴 Setup: 컴컴� Ok, this ppe assumes that you have violator set up in C:\VIO and that your command prompt filename is COMND.396. If not, you will have to trash this for now. I am working to make this configurable, but I am lazy... I will get to it. Pretty easy to install... put the file PROLGN.PPE in your SCAN296 file, which is in your C:\VIO directory. Then, your SCAN296 file should look like this: !C:\PCB\PPL\PROLGN.PPE Scan for new messages? Or something like that. Just remember to put the exclamation point and etc. Next, put your PROMPT.PPE in your CMDS.LST by going to PCBSETUP and pressing 'B' twice. then scroll down to the file C:\PCB\GEN\CMDS.LST (or something) and press F2. Now add an entry: Key Security Path 컴� 컴컴컴컴 컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴컴� S 0 C:\PCB\PPL\PROMPT.PPE Edit the paths as they suit you. Now, copy your COMND.396 to your main PCBoard directory. Ok, use any handy-dandy text editor and go into your $$LOGOFF.BAT file. This file should be in your PCBoard directory (ie C:\PCB). If you don't have this file, create it. Then, goto the end of the file and add something like this: COPY C:\PCB\COMND.396 C:\VIO This should be it. If you have any problems, suggestions, etc, you can reach me on my board, Solar Eclipse - 609/799-5730 or on The Spade - 609/443-5789. If you would like to register this PPE, please call Solar Eclipse and leave feedback. Registration enables you to become a Beta Test Site if you'd like, and when Version 1.0 is released, you will have the deluxe version, which will enable configurable menus, a max of 20 prompts, and gets rid of the tiny delay which is in there... Later everyone, hope you enjoy my first PPE... coming soon - a Full Screen, Blind Upload PPE, and a NUV PPE, if I can figure out how PCBoard works. Signin' off, aerosol [lithium/lupus/pow]