GETSPEED.PPE 1.0 08/08/97 PCBOARD 15.3+ PLC 3.3
SETUP
1st make sure PSA(5) Statistics is installed. if it isn't,
program will tell you and stop operating. which means run
the included GETSPEED bat file from DOS after putting a .bat
extention on it. plus change the path info in the file.
To test it.
If it runs your almost done.
2nd. Assuming you put your path info in GETSPEED move that file
to your PCB directory and go into PCBSETUP and add the event
GETSPEED.
3rd Now you did the hard part put the .ppe and .ans file together
in the directory you specified in GETSPEED.
4th ADD the Bulletin GETSPEED.BLT to your bulletin list in PCBSETUP
it's generated to the directory you put the .ppe in
the sample .blt is not needed.
Comments/Problems/Gratuities
MR. E. Ken
Kasa Entertainment-Presents
810-228-7496 6pm - 6am DAILY
INTERNET KASA2@JUNO.COM
FIDONET SYSOP@1:120/523
USNETMail SYSOP@587:120/0
43121 CARLYLE PL. DR. 203A
CLINTON TWP., MI 48038 U.S.A.