-/-  REVOLVE.PPE version 1 -\-


-/- What is REVOLVE.PPE? -\-

   REVOLVE.PPE is a simple .PPE desingned to revolve other .PPEs instead of 
just using the one.  I desinged it because I have a couple of cool enter 
prompt replacements that I like and I didn't want to only be able to use 
one.

-/- Instalation -\-

   Instalation is reletivly easy.  First make a dir like C:\PCB\PPE\REV and
unzip this file into it.  Second edit the config file (REVOLVE.CNF) to echo 
your setup (there is a line by line description in the file, but if you 
happend to lose or erase it, the config file for it is listed at the bottom
of this doc).  Third Use MKPCBTXT to edit the PCBTEXT file so that prompt 
418 (or whatever one you are replacing) so that it looks like this:
 
!C:\PCB\PPE\REV\REVOLVE.PPE (with your path to the REVOLVE.PPE instead). 

Now load up PCB local and look at your cool work!


-/- Start REVOLVE.CNF -\-
3
C:\PCB\PPE\ENTER\DKENTER.PPE
C:\PCB\PPE\ZEN\Z-ENT.PPE
C:\PCB\PPE\BOUNCE\B-ENT.PPE
NONE
NONE

-/- Line Descriptions -\-

Line 1 is the number ppes your are going to be revolving (This MUST be line 1)
Line 2 is the FULL path to the first .PPE
Line 3 is the FULL path to the second .PPE
Line 4 is the FULL path to the third .PPE or NONE
Line 5 is the FULL path to the fourth .PPE or NONE
Line 6 is the FULL path to the fifth .PPE or NONE

	
-/- Credits -\-

	REVOLVE.PPE was programmed by Jim Jones of ALF.  If you have any
Comments or would like a .PPE programed for a specfic purpose, feel free
to contact him on Either Channel Express (914) ALF WHQ or his board,
Refuge Of The Dammed (916) and leave a message explaining exactly what you
would like the .PPE to do. 

	Later Kidz
	Jimmie