+-----------------------------------------------------------------------------+
| Enhanced End of Message v1.2                                                |
| Written by Drew [PWA]                                                       |
| Docs Last Updated 02-26-95                                                  |
+-----------------------------------------------------------------------------+


+-----------------------------------------------------------------------------+
| 0. Table of Contents                                                        |
+-----------------------------------------------------------------------------+
    1. Introduction
    2. Installation
    3. Configuration
    4. Last Words


+-----------------------------------------------------------------------------+
| 1. Introduction                                                             |
+-----------------------------------------------------------------------------+
    See HISTORY.DOC for all changes.  Otherwise, Enhanced End of Message is a
PPE which replaces your end of message prompt with a nice and attractive
hotkey and lightbar driven prompt.  Since this was written in PPL 3.0, you
must be running PCBoard 15.2+ in order to use this.


+-----------------------------------------------------------------------------+
| 2. Installation                                                             |
+-----------------------------------------------------------------------------+
    If you are upgrading from any previous version, simply replace the old
EEOM.PPE.  One extra line (#3) is added in EEOM.CFG, so take a look at the
one included in this version for the description.

    Simply run INSTALL.BAT or you can manually edit your PCBTEXT and have
prompts 197 and 612 point to this ppe.  IE: !C:\PCB\PPE\EEOM\EEOM.PPE

    For those of you who beta tested this and are a running a copy of EEOM
prior to this release, please replace your old EEOM.PPE.


+-----------------------------------------------------------------------------+
| 3. Configuration                                                            |
+-----------------------------------------------------------------------------+
    Edit EEOM.CFG to change the two options available inside.  Edit LB.CFG for
text and colours associated with the lightbars.  Edit STRINGS.CFG for all text
strings and prompts which get printed.  Each file is rather small and could
have been put in one big file, but it is more organized in this manner.

    Edit EEOM.PCB for the header that is displayed before the main command
prompt is printed.

    The PPE will still function without any of these files, as then it will
use the built-in defaults.  However, it most likely clash with your board's
colour scheme. :)


+-----------------------------------------------------------------------------+
| 4. Last Words                                                               |
+-----------------------------------------------------------------------------+
    Just about every PCB system I'm on uses either CEOM or an old CIA Footer
ppe.  CEOM by MS is nice and all, but seeing either 3 or 4 lines for a prompt
such as this drove me nuts.  As for the CIA Footer ppe, it just wasn't very
configurable.  So hence, I broke down and wrote this out of fear of going
insane.

    Otherwise, if you need to reach me for some reason, you can send internet
email to "drew@xinet.com", or leave me a message on Attitude Net, or call my
board: The Silicon Phalanx at 310-575-8567 and apply for access.

Peace,
--Drew