FLEXIBAK Plus v 3.00 README.DOC FILE
                ====================================

1) Running FLEXIBAK Plus:

        From the "C:\>" prompt, type "CD \FLEXPLUS" <ENTER> to change to
        the FLEXPLUS directory followed by "FLEXPLUS" <ENTER> to run
        FLEXIBAK Plus.


2) The Quick Start Guide:

        To enable you to start backing up in the minimum time possible,
        refer to the file QUICKST.DOC which will guide you through
        setting up and taking a backup. There is also a section
        describing how to restore your data if necessary.


3) Upgrading From Previous Versions:

        Version 3.00 is compatible with all previous v 2.0x releases of
        FLEXIBAK Plus, but not with any earlier versions of FLEXIBAK
        Plus. Consequently, if you have been running a version 1.0x
        release, you will need to go through the setup procedures again
        and take a new full backup. To make this process easier, you
        should first run your existing version and produce a File Specs
        Report. This will allow you to more easily duplicate the setup.


4) File List:

        The following files should be present on your distribution disk.
        If they are not, then you should contact Nildram Software as you
        have an incomplete version.

                INSTALL.EXE  - Installation program
                INSTALL.FIL  - Installation program script
                INSTALL.DOC  - Installation instructions
                INSTALL.FP   - FLEXIBAK Plus program and documentation files
                INSTALL.REG  - For registered users only!
                VENDOR.DOC   - Info for Shareware Vendors and BBSs
                HISTORY.DOC  - Version history
                DEALER.DOC   - List of dealers for FLEXIBAK Plus worldwide
                README.DOC   - This file
                REGISTER.DOC - Registration form
                DESC.SDI     - File description for use by Wildcat BBSs
                FILE_ID.DIZ  - File description for use by PC Board BBSs

        If you are a registered user, and you wish to give away a shareware
        copy of FLEXIBAK Plus to a friend or colleague, you can copy all of
        the files, except INSTALL.REG to a disk, and give it to him/her.
        This will then be a standard shareware copy. You may not, under any
        circumstances, give away copies of the file INSTALL.REG.


5) BBS Support:

        FLEXIBAK Plus is supported on the following BBSs:

        i) Shareware Support BBS, UK - (0442) 891109/890807 HST/V32 etc.
        Leave messages addressed to the SYSOP.

        ii) Runway BBS, USA - 215-623-6203 HST/V32 etc. Join conference
        77 (Shareable Software International) and address messages to
        Bill Dickson.

        iii) Compuserve - UK Version is available in UKSHARE Lib 10, USA
        version in IBMSYS Lib 6. Leave messages in UKSHARE forum 10 or send
        as private Email to Adrian Mardlin 76004,3436 (UK) or Bill Dickson
        76226,2652 (USA).

        iv) FLEXIBAK Plus is also uploaded to over 200 BBSs in the USA, and
        over 20 BBSs in the UK. Look for PC Board or Wildcat BBSs running
        at 9600 bps or better - you should find it there.