; ---------------------------------------------------------------------
;              English language text file for KSP-FTP v2.8
; ---------------------------------------------------------------------
; 
; IMPORTANT: 
;
;	Make this file read-only if you have a multi-node BBS!
;	Lines beginning with a semicolon are comments and are ignored.
;	Do not rearrange the order of these lines, other than to
;		insert or remove comment lines.
;	Do not remove or modify any substring that begins with '%'!
;		(They are replaced at runtime by computed values.)
;	Some lines below may begin or end with a space which should
;		be preserved.
;
; "Escapes" are replaced as follows:
;
; 	\r 	carriage return
;	\n	line feed
;	\7	rings the bell
;	\t	horizontal tab
;
Baud rate below minimum required: %ld!\r\n
You have %u minutes remaining.\r\n\n
Can't read file
Can't close file
FTP requires 8N1 communication
FTP hours of operation are %s\r\n
This protocol needs BBS disk space to temporarily store files.\r\n
Each GET or PUT command is limited to no more than %ld MByte(s).\r\n
Do you wish to continue (Y/n): 
\rTransferring file '%s' from BBS to remote host...\r\n
\rTransferring file '%s' from remote host to BBS...\r\n
Can't create file '%s'!\7\r\n
Can't write to '%s'!\7\r\n
\r\nOptions:
 min/kb)
 min)
closed
File Transfer Protocols Available:\r\n
(download only)
Enter selection
File Transfer Protocol: %s\r\n
Unchanged
Transfer cancelled by user
Time out waiting for data
Unexpected byte value received
Bad checksum received
Bad packet number received
Network error
File not found
Waiting to receive file(s) using %s protocol.\r\n
Send ^X several times to cancel transfer.\r\n
Waiting to send file(s) using %s protocol.\r\n
Press ^X several times to cancel transfer.\r\n
Commands (may be abbreviated):
enable ascii ftp transfers
enable binary ftp transfers
quit ftp and logout from BBS
change remote directory
close current connection
delete remote file(s) (*,? ok)
detailed directory list (*,? ok)
download remote file(s) (*,? ok)
brief directory list (*,? ok)
create directory on remote host
toggles "more" prompt at end of page
open connection to remote host
send password to remote host
set serial transfer protocol
display current remote directory
quit ftp and return to BBS
remove directory on remote host
display a remote text file
upload file(s) to remote host
send username to remote host
display this help
Usage:
Image\r\n
Ascii\r\n
Logical bytesize %u\r\n
Invalid type %s\r\n
Delete file '%.80s'? (y/N): 
Download KB limit exceeded!\7\r\n
Temporary storage capacity exceeded!\7\r\n
Enter password: 
File Transfer Protocol: %s\r\n
Unchanged
Enter user name [anonymous]: 
Verifying file existence.
No matching files!\7\r\n
"More" prompt enabled.\r\n
"More" prompt disabled.\r\n
Enter Remote Host ID: 
Invalid IP address!\7\r\n
Looking up '%s' 
 [failed!]\7\r\n
 [done].\r\n
Trying %s 
\r\nConnected to %s\r\n
Not a valid hostname or IP address!\7\r\n
\r\nLicense limit(s) exceeded - try again later.\r\n
\r\nInactive Timeout!\7\r\n
\r\nLost Carrier!\7\r\n
\r\nBBS Time Expired!\7\r\n
\r\nFTP Internal Error!\7\r\n
Returning to BBS.\r\n
Hanging up!\r\n
 [Timed out!]\7\r\n
 [Closed by remote host]\r\n
 [done]\r\n
error
 [User Abort!]\7\r\n
More? (Y/n/ns): 
NS
N
\rBytes Transferred: %lu
No time remaining
All access to this host has been blocked\n
Requesting true hostname
; -----------------[ End of file ]----------------------------