Audio Device Driver For Boards
                      With the Vibra Chip, VIBR16D2.SYS
                          For OS/2 2.1, 2.11 & Warp
			       March 27, 1995


******************
   INSTALLATION
******************

 (1) Use either MINSTALL (on OS/2 2.1 & 2.11) or SELECTIVE INSTALL (on OS/2 Warp) 
     to install for Sound Blaster 16.
 (2) Copy the driver, VIBR16D2.SYS, to your \MMOS2 directory.
 (3) Modify the name of the driver from SB16D2.SYS to VIBR16D2.SYS in the 
     following line in your CONFIG.SYS file:
     For example, change,
       DEVICE=C:\MMOS2\SB16D2.SYS x x x x xxx x xxx /N:SBAUD1$
     to,
       DEVICE=C:\MMOS2\VIBR16D2.SYS x x x x xxx x xxx /N:SBAUD1$


****************************
  Some Helpful Information
****************************

Driver Parameters In CONFIG.SYS File
------------------------------------
The following parameters are used for the audio driver:

DEVICE=C:\MMOS2\VIBR16D2.SYS DEVNO DMA HDMA INT IOADDR BUFSIZE MPUADDR /N:DRVNAME

where

DEVNO is the audio device number (usually 1)

DMA is the 8-bit DMA channel to be used by the audio card (default: 1)

HDMA is the 16-bit DMA channel to be used by the audio card (default: 5)

INT is the interrupt level to be used by the audio card (default: 5)

IOADDR is the I/O address of the audio card (default: 220 hex)

BUFSIZE is the buffer size in kilobytes (default: 4)

MPUADDR is the MPU-401 interface base address (default: 330 hex)

DRVNAME is the device driver name used by MMPM/2 subsystems