Canon BJ Printer Driver Version 1.07 for AutoCad R12

To correct for the paper feed slippage apparent with the 3X0
printers the printer driver may be calibrated.  Note that
the paper motion is in the X direction (ie the Y direction
should not need calibrating).  The slippage is dependent on the
paper width (and type) so you may need to set up several copies
of the driver for different widths.
		
After calibration you will still see slight jaggies where the
print head bands overlap, but the overall length will be 
better.
		
The instructions on page 43 & 44 of the Installation manual may
be used to calibrate the plotter, but you will have to re-
answer the plotter specific questions (including the 
plotter model) first to get to the "generic" questions 
that allow you to enter the calibration factors (simply 
use the defaults for the plotter questions).

The installation manual says that the calibration may be
cancelled by entering the same plotter name after saying that
you want to choose a new one, note that this is also within
the Change Plotter sub-menu.

Show Device Requirements will say "calibrated" on the
line which displays the resolution if this has been done.