STANDARD MICROSYSTEMS CORPORATION

                             Sun PCNFS v3.5
                For TokenCard EliteSeries LAN Adapters

                            INSTALLATION GUIDE

     This software is licensed by SMC for use by its customers only.
         Copyright (c) 1993 Standard Microsystems Corporation.
                         All rights reserved.


This installation guide describes:

o  How to use EZStart to copy the SUN PCNFS version 3.5 NDIS 
   driver files from the SuperDisk to your PC.
   
o  How to prepare your PC's operating system so you can attach 
   to the network.

Note: This driver supports all SMC TokenCard EliteSeries 
      ISA and Micro Channel Token-Ring adapters.


COPYING THE DRIVER FILES

From the Driver Installation screen, select 'Copy Files' to copy 
all the files used by this driver from the SuperDisk to the
Destination Directory recommended by EZStart, or to a different 
directory that you specify.


PREPARING YOUR OPERATING SYSTEM

1. Insert the Installation and Connections diskette into a
   disk drive (A:\ or B:\).

2. Type: INSTALL

3. Press the Enter key.

4. Specify the destination drive letter (usually C) and press 
   Enter.

5. Specify "Ethernet" and press Enter.

6. Select the "NDIS" option.

7. Follow the screen prompts to copy the PCNFS files to your
   destination drive.

8. When prompted, press Enter to configure PCNFS.

9. Specify the PC name, IP address, server name, and server IP 
   address. If you need assistance, refer to the "Configuring PC-NFS" 
   section of your Sun PC-NFS Installation Guide.

10. Follow the screen prompts to complete the installation.

11. When the installation is complete, select Quit to exit the
    configuration program, defer the boot, and return to DOS.

12. Using any text editor, add the following line below the
    NFS_NDIS.SYS driver specification in your CONFIG.SYS file:

         device=c:\lanman\SMC8100.dos

   Note: The 'c:' shown in the line above indicates the destination
         drive you selected during the PCNFS installation.

13. Use any text editor to edit the PROTOCOL.NFS file in the 
    \LANMAN subdirectory in your Destination Directory (do not edit
    the \LANMAN subdirectory on your SuperDisk):

    - Replace:

              [YOUR-MAC-MODULE]

      with:

              [SMC]

    - Replace:

              drivername = yourmac$

      with:

              drivername = SMC8100$


    - Remove the line:

             option1 = value1 etc.

    - Replace:

             bindings = YOUR-MAC-MODULE

      with:

             bindings = SMC

    - Locate the file PROTOCOL.NFS in the \LANMAN subdirectory on
      your destination drive and rename it to PROTOCOL.INI. Refer to
      your DOS manual if you need assistance.

    - Add the following NETBIND statement just before the NFS RUN 
      statement in your AUTOEXEC.BAT file:

            C:\LANMAN\NETBIND
            NFSRUN

   Note: The 'c:' shown in the line above indicates the destination
         drive you selected during the PCNFS installation.

14. Turn your computer off and then on.


SMC and Standard Microsystems are registered trademarks; and 
TokenCard, TokenCard Elite, TokenCard Elite/A, Elite Series, 
EliteView, EZStart, and SuperDisk are trademarks of Standard 
Microsystems Corporation.  Other products and company names are 
registered trademarks or trademarks of their respective holders.