ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
   ³                  Installation for PATHWORKS for DOS                    ³
   ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ


   You can use the DECnet PathWork's NETSET.EXE program to install the
   NDIS driver program.  Please refer to DECnet installation manual for
   detailed information.   The following instructions assume that you have
   already installed the DECnet PathWork with 3Com's Etherlink II card.

   1. Modify your CONFIG.SYS file as follows:

           device = c:\decnet\ELNKII.SYS
                           to
           device=c:\decnet\UM9008.DOS


   2. Modify the PROTOCOL.INI file as follows:

           from:
           ---------------------------------
                   [ELNKMACII]
                   drivername = ELNKII$
                   ioaddress = 0x300
                   interrupt = 3
                   xmitbufs = 2

                   [IPX4MAC]
                      :
                   bindings = ELNKMACII
                      :

                   [DATALINK]
                      :
                   bindings = ELNKMACII
                      :

           to:
           -----------------------------------
                   [UM9008]
                   drivername = UM9008$

                   [IPX4MAC]
                      :
                   bindings = UM9008
                      :

                   [DATALINK]
                      :
                   bindings = UM9008
                      :