LAN Server 4.0
--------------

   Introduction:
   -------------
   This document describes the procedure to install NDIS driver on
   OS/2 LAN server 4.0 for NE100TX-E PCI Fast Ethernet Card.

   Location of Driver:  \NDIS.OS2\NE100TX.OS2  (for OS/2 LAN Server)


   Installing driver procedure on OS/2 LAN Server 4.0:
   ---------------------------------------------------
      Before you start with the installation  process,  make sure that
      OS/2 LAN Server  is properly installed.  Similarly, your adapter
      should also be properly installed in your server.

      1. In OS/2 window, Click the "MPTS" icon.

      2. The screen will display the IBM Log, press "OK".

      3. Select "Install" button.

      4. Insert the NE100TX-E PCI Fast Ethernet Card driver diskette, specify 
         the driver path A:\NDIS.OS2 and press <Enter>.

      5. When complete above step to load  NE100TX.OS2  into OS/2 system,
         then configure your system.

      6. The same step as step 3, select "Configure" button.

      7. The screen will display "Configure" dialog box and select "LAN
         adapters and protocols" then press "configure" button.

      8. The screen will display "LAPS Configuration" dialog box, move
         highlight to "NE100TX-E PCI Fast Ethernet Adapter" item in "Network
         Adapter" window, and select "NetBios" protocol. Press "OK".

      9. Installation is complete now. Reset your PC by turning it off
          and on.
-----------------------------------[ END ]-------------------------------------