LAN Manager Server
------------------

   Introduction:
   -------------
   This document describes the procedure to setup LAN  Manager 2.X
   Server driver for ND4300 PCI Ethernet Adapter.

   Location of Driver: \MSLANMAN.OS2\DRIVERS\ETHERNET\ND4300\ND4300.OS2
                      

   Sample Configuration Files:
   ---------------------------
      CONFIG.SYS (will contain):

          DEVICE=C:\LANMAN.OS2\DRIVERS\PROTMAN\PROTMAN.OS2 /I:C:\LANMAN.OS2
          DEVICE=C:\LANMAN.OS2\DRIVERS\ETHERNET\ND4300\ND4300.OS2


      PROTOCOL.INI (will contain):

         [ND4300_NIF]
         ; PROTOCOL.INI SAMPLE

           DriverName = ND4300$
           
   Setup Procedures:
   -----------------
      Before you start with the installation process, make sure that the
      adapter  is properly  installed and  configured.  Make  sure  your
      Microsoft LAN Manager is properly installed.

      1. Run the appropriate Microsoft Lan Manager SETUP for computer you
         are setting up.(OS/2 Server). Select "Configuration"
         item ,(the ND4300 PCI Ethernet Adapter driver isn't included on the 
         Lan Manager disk) and insert the ND4300 PCI Ethernet Adapter driver 
         disk, select the "ND4300 PCI Ethernet Adapter" and follow the 
         directions.

      2. When completed, reboot your computer .


   NOTES:
   ------

      Sample PROTOCOL.INI for LAN Manager:

           [PROTMAN]
           DRIVERNAME = PROTMAN$
           DYNAMIC = YES
           PRIORITY = NETBEUI

           [NETBEUI_XIF]
           Drivername = netbeui$
           SESSIONS = 6
           NCBS = 12
           BINDINGS = "ND4300_NIF"
           LANABASE = 0

           [ND4300_NIF]
           ;
           ; PROTOCOL.INI Sample Adapter
           ;
           DriverName = ND4300$
         

-----------------------------------[ END ]-------------------------------------