This README file describes how to enable the RPL function on
workstations with a bootable hard disk.  Two utilities,
NDCRPLEN.EXE and NDCRPLDS.EXE, are provided for enabling the
RPL function on workstations with bootable hard disks.

Since both Instant-Link and ND41xx products are software confi-
gurable, the first thing to enable the RPL function is to run
the configuration software to determine the RPL segment address.

To use your adapter's (Instant-Link and ND41xx) RPL function and
boot your PC workstation from the network server, you must enable
the RPL function on the workstation by turning the hard disk (if
present in the workstation) into a non-bootable device.
    - NDCRPLEN.EXE, allows you to deactive your hard disk's boot
      partition and enable the RPL function while keep your hard
      disk accessible.
    - NDCRPLDS.EXE, allows you to re-activate your hard disk's
      boot partition and disable the workstation's RPL function.

Note:
 * The NDCRPLDS.EXE program assumes your hard disk boot device to
   be Drive C:.  If you don't use drive C: to boot your workstation
   you must use the DOS FDISK.EXE command to activate your hard
   disk's boot partition.
 * The NDCRPLEN.EXE and NDCRPLDS.EXE programs are in RPL directory
   of this diskette.


*****************************************************************
This section of the README file applies only to the NDET06 RPL
modules used on the Instant-Link and ND41xx products for NetWare
server.
*****************************************************************

To enable the RPL function on a workstation installed with an
Instant-Link or ND41xx adapter and the NDET06 RPL Module,
accomplish the following steps to boot from your NetWare server.

(1) Login as supervisor to the NetWare 3.1X server. Copy
    "RBOOT.RPL" to the F:\LOGIN directory and "RPL.NLM" to the
    F:\SYSTEM directory.

(2) Load RPL.NLM and then Bind RPL to the Ethernet driver with
    ETHERNET_802.2 frame in NetWare server. A sample of the
    commands to type follows:

        :LOAD NE2000 frame=ETHERNET_802.2
        :BIND IPX TO NE2000
        :LOAD RPL
        :BIND RPL TO NE2000

Note:
 * "RBOOT.RPL" and "RPL.NLM" in RPL directory of this diskette
   are for NetWare 3.1X server. You don't have to do step (1) for
   NetWare 4.0X server since these two files are included in it as
   default.