Driver installation Guide for NetWare OS2 ODI client
       ==========================================================

Introduction
============
    This document describes the procedures to install  Netware OS2 ODI
    driver for AE-200PNP Ethernet Adapter.

    NetWare OS2 ODI client network OS does not support Plug&Play feature
    and if your computer doesn't support PnP function also, you must set
    the LAN card in  "Jumperless" mode through our PNPSETUP.EXE program;
    Otherwise, it can not work correctly.


Installation Procedures
=======================

    Before you start with the installation procedure, make sure that the
    adapter is properly installed and configured.  Similarly, Make sure
    that your NetWare Requester for OS/2 is properly installed.

    Please refer to "Novell NetWare Requester for OS/2" documentation for
    a detailed	Requester and Utilities installation guide.

    1. Copy the PNPOS2.SYS  file into the NETWARE subdirectory of your
       hard disk from the Driver Diskette A:\NETWARE\OS2ODI.

    2. Add or replace the PNPOS2.SYS in the CONFIG.SYS file.

    3. Edit the NET.CFG file that you copied over. Edit the file per your
       requirements (see examples above).  If there are two frame types
       listed, whichever frame type is listed first, that is the one that
       the driver will load.  See above for examples.

    4. Reboot your system to get service of network.


    --- Sample	CONFIG.SYS file ---

	 DEVICE=C:\NETWARE\LSL.SYS	    ; OS/2 Requester supported
	 DEVICE=C:\NETWARE\DDAEMON.SYS	    ; OS/2 Requester supported
	 DEVICE=C:\NETWARE\PNPOS2.SYS	    ; Manufacturer supported
	 DEVICE=C:\NETWARE\IPX.SYS	    ; OS/2 Requester supported

    --- Sample NET.CFG file ---

	 LINK DRIVER PNPOS2
	      FRAME ETHERNET_802.3
	      FRAME ETHERNET_802.2