Installation instructions
=========================

1. To install from floppy, you will need two 1.44MB floppies.
   1.1. COPY DISK1\*.* A: /S/E/V
   1.2. LABEL A:DISK1
   1.3. COPY DISK2\*.* A: /S/E/V
   1.4. LABEL A:DISK2
   1.5  Load install at server console and enter A:
	for the installation path.

2. To install from local system volume:
   For example:
   2.1. Create a TEMP Directory (sys:temp) and put DISK1 and DISK2 there.
   2.2. Load install at the server console and enter
	SYS:\TEMP\DISK1 for the installation path.

This installation method is only for 4.1x server.
================================================
3. To install from a workstation to any 4.1x server
   3.1 Create a TEMP on any drive (local or network) and put DISK1 and DISK2             there.
	 For example:
	   C:\TEMP\DISK1 or F:\TEMP\DISK1
			\DISK2          \DISK2

3.2 If Rconsole and remote install are not already enabled, then enable Rconosle and remote install on the remote server via INETCFG.NLM and reinitialize system.

   3.3 From your client, Rconsole to the remote server.
	 For example:
		F:\public\Rconsole <target servername>
		Provide ADMIN password and load INSTALL at the server console.

   3.4 Make sure you Press <F4> instead of <F3> or <ENTER> when asked for source        path and then enter C:\TEMP\DISK1\RINSTALL or F:\TEMP\DISK1\RINSTALL.