2.4  NetWare NT Client


The drivers for EtherTeam16i NT Client can be  found  from  the  subdirectory
NETWARE\NT have the following file names:

    ETH16I.LAN    ODI Driver (Specification 3.1).
    OEMSETUP.INF  OEM Setup File
    ETH16I.HLP    OEM Setup Help File


To install the NetWare NT Client for ICL EtherTeam16i, do the following:

 1. If  needed,  use the EtherTeam16i Configuration Utility to check that the
    I/O Base Addresses and IRQ Numbers of the adapters to be installed do not
    conflict with any other adapter(s).

 2. Use the Windows NT Control Panel to install the  driver.  Give  the  path
    A:\NETWARE\NT when prompted for the OEM Driver diskette.


     1. Select  the  I/O  Base Address according to the EEPROM Setup value of
        your adapter. The default AUTO means that  the  adapter  is  searched
        from the possible I/O Base Addresses.

        NOTE!  In  case of several adapters installed, the I/O Base Addresses
        must be given explicitly.


     2. Select the Interrupt Number according to the EEPROM  Setup  value  of
        your  adapter.  The default AUTO means that the Interrupt Number from
        the Setup EEPROM is used.

        NOTE! If the Interrupt Number is given explicitly, it can't  override
        the Setup value on the EEPROM but must match with it.


     3. Select   the  Transceiver.  The  value  SETUP  here  means  that  the
        transceiver definition from the Setup EEPROM  is  used  (Its  factory
        setting is AUTO).

        If  the  transceiver is given explicitly (BNC, TP or AUI), then it is
        used. Otherwise (AUTO) the driver detects automatically  the  network
        connection  (provided  that  the cable is connected while booting the
        system).