3490E NDIS Driver 


 
        PROTOCOL.INI file configuration for DOS

              DRIVER = C3490E$
              INTERRUPT = <number>
              MEM = <address>
              SLOT = <number>
   
              Interrupt choices are:

                       3, 5, 7, 9, 10, 11, 12, 15

              MEM choices for DOS are:

                        memory address   0x0d0000

     *** NOTE: To use the following addresses HIMEM.SYS must be used ***

                        memory address  0x0ff0000
                        memory address  0x0fe0000
                        memory address  0x0fd0000
                        memory address 0x0fff0000
                        memory address 0x0ffe0000
                        memory address 0x0ffc0000
                     
                                              
               Slot number where 3490E is installed.

                       1 THROUGH 8


              Installation Instructions

           1) Make a diskcopy of this diskette.

           2) Note the configuration of the 3490E during EISA configuration.
              You will edit the PROTOCOL.INI file per above choices **after**
              completing the EISA configuration.
              
              Set the parameters in the PROTOCOL.INI exactly as in the EISA 
              configuration for the 3490E for the specific installation 
              you are making. 
             
              Edit the PROTOCOL.INI file in the 
              A:\MSLANMAN.DOS\DRIVERS\ETHERNET\3490E directory. 

           3) Use this diskette as the last diskette prompted for during
              installation of LANMAN 2.0.

           4) Once LANMAN is installed, you can use the IMPORT utility
              from SETUP by inserting this diskette when requested.