3Com (R)  Corporation 
NDIS 2.01 Drivers Installation Notes 


IBM LAN Server v4.0 for OS/2
============================

This procedure describes how to install the NDIS driver 
for LAN Server 4.0.  OS/2 must be already installed on 
your computer.  To install the NDIS driver for the 3Com 
EtherLink III Family adapter, follow these steps:

 1. Open an OS/2 prompt.

 2. Insert the LAN Server MPTS (Multi-Protocol Transport 
    Services) disk 1 in your floppy drive.  

 3. Make that drive your current drive.  Type: 
       A: [Enter]

 4. Type:
    Install [Enter]

 5. Select OK.

 6. Select Install.

 7. Select a target drive and then choose OK.

    The default drive is C.

 8. Insert disk 2 when prompted and select OK.

 9. Select OK when the MPTS installation is complete.  

10. Select Configure.

11. Select LAN Adapters and Protocols 
    and then choose Configure.

12. Select Other Adapters and then choose OK.

13. Insert the 3Com EtherDisk diskette in the 
    floppy drive and enter the drive letter and path to 
    the 3Com NDIS drivers.  For example, type:

      A:\NDIS\OS2

14. Select OK.

15. Select 3Com EtherLink III family adapter for 
    OS/2 and then choose Add. 

16. Under Current Configuration, select 3Com 
    EtherLink III adapter for OS/2 and then choose 
    Edit. 

17. Enter the 12-digit address of your EtherLink 
    III Family adapter and then choose OK. 

      The address is found on the 3Com EtherLink III adapter     
      following the characters EA=.  

18. Select the protocol(s) you will be using with 
    your network and then choose Add.  

19. Select your protocol(s) under Current 
    Configuration and then choose Edit.

20. Enter the 12-digit address of your 
    EtherLink III Family adapter and then choose OK.  

21. Select  OK. 

22. Select  Close.  

23. Select  Exit.  

24. Select Update CONFIG.SYS and choose Exit.  

25. Select OK.

26. Select Exit.

27. Quit OS/2 and reboot for the changes to take effect.

28. Follow the IBM instructions on installing 
    LAN Server to complete the installation.




IBM LAN Server v4.0 for DOS
===========================

IBM DOS Lan Services Install v4.0


1. Insert the disk labeled DOS LAN Services Disk 1 into 
   your disk drive.

2. Change to that drive and type: 
   
   INSTALL

3. Choose the directory where you want the software installed.
   The default is C:\NET.

4. A menu appears that provides a list of network cards.
   Choose "Network card not shown in the list below..." 

5. Type:

   A:\NDIS\DOS and remove the DOS LAN Services Disk 1
   diskette and insert the Etherdisk diskette.

6. The next menu should display 3Com EtherLink III 
   Family.

7. Additional menus will appear. Choose the appropriate options
   for your network environment. Refer to the IBM manual if 
   there are questions regarding these menus.

8. After completing the installation, you must copy ELNK3.DOS 
   to C:\NET before rebooting.


=========================================================



(%VER NDIS - IBM LAN Server v2.1b)