THE MOUSE SYSTEMS CORPORATION

MSCMOUSE DRIVER v 7.10

  Your Mouse Systems Software package contains two Mouse drivers:  
  MSCMOUSE.SYS and MSCMOUSE.COM.  The MSCMOUSE.SYS mouse driver can only be 
  used in the CONFIG.SYS file where the MSCMOUSE.COM can be used either
  in your AUTOEXEC.BAT or anytime at the DOS prompt.


COMMONLY USED COMMAND LINE OPTIONS

  The following are common command line parameters to be used with the mouse 
  driver.  Enter command:

        MSCMOUSE <arg>

	where <arg> represents one or more of the following:

        /1    Direct Mouse Driver to COM1     
        /2    Direct Mouse Driver to COM2
        /C    Direct Mouse Driver to Bus Card
        /P    Direct Mouse Driver to PDP port (IBM PS/2)
        /A0   Disable acceleration and set resolution back to the default
        /A#   Invoke High-Resolution dynamic acceleration level (1 - 9)
	/E    Enable/Disable resolution doubling
	/I    Enable/Disable application defined mouse sensitivity
        /U    Unload MSCMOUSE and POPUP drivers to release memory
        /?    Exercise help parameter list

  For example, the following commands will direct the mouse driver to COM2, set
  the mouse acceleration to 8, set the base resolution to 200-DPI (assuming a
  100-DPI mouse), and disable an application program's ability to set its own
  mouse sensitivity:

  1. In the AUTOEXEC.BAT (or at the command line/DOS prompt):

	MSCMOUSE /2/A8/E/I           (NOTE!! Could also be: mscmouse /2/a8/e/i)
                   or
        \MOUSE\MSCMOUSE /2/A8/E/I
                      (If you copy MSCMOUSE.COM to a subdirectory called MOUSE)

  2. In the CONFIG.SYS:

        DEVICE=MSCMOUSE.SYS /2/A8/E/I
                   or
        DEVICE=\MOUSE\MSCMOUSE.SYS /2/A8/E/I
                      (If you copy MSCMOUSE.SYS to a subdirectory called MOUSE)  

                  
SETTING MANUAL ACCELERATION

  To set mouse acceleration manually, press CTRL + ALT + Left Mouse Button.       After the beep, release the three keys and press any number 0 - 9 on the
  keyboard.  If you do not make a valid selection within 6 to 8 seconds, the
  mouse driver will beep three times and return you to your application with
  the mouse set as before.  Otherwise, there will be two beeps and you will
  return to your application with a new acceleration level. 
  

PROBLEMS	

  If you are experiencing any problems with either your Mouse Systems mouse
  or the software, please contact us at:


			MOUSE SYSTEMS CORPORATION
			47505 SEABRIDGE DRIVE
			FREMONT, CA 94538
			PHONE: (415) 656-1117
			FAX: (415) 770-1925
			BBS: (415) 683-0617