Figure 1 Jumper Location
Figure 1 shows the location of the jumpers to select drive configuration and functions.
Figure 2 Factory default setting
Figure 3 Jumper setting of master or slave device
(2) Cable Select(CSEL)
In Cable Select mode, the device can be configured either master device
or slave device. For use of Cable Select function, Unique interface cable
is needed.
Figure 4 Jumper setting of Cable Select
Figure 5 and Figure 6 shows examples of cable selection using unique interface
cables.
By connecting the CSEL of the master device to the CSEL Line (conductor)
of the cable and connecting it to ground further, the CSEL is set to low
level. The device is identified as a master device. At this time, the CSEL
of the slave device does not have a conductor. Thus, since the slave device
is not connected to the CSEL conductor, the CSEL is set to high level.
The device is identified as a slave device.
Figure 5 Example (1) of Cable Select
Figure 6 Example (2) of Cable Select
to the table of contents!!