NEC MONOGRAPH
                    UTILITIES AND DIAGNOSTICS
                          Version 1.20


This is the Utilities and Diagnostics diskette for the MonoGraph. 
It is one of three diskettes provided with your MonoGraph System.

On this disk, you will find the following files:

MGDIAG.EXE   - This program allows you to determine if your
               MonoGraph graphics controller is operating
               correctly.  You will find the diagnostic test
               operating instructions in the chapter entitled
               "Troubleshooting and Diagnostic Testing" of your
               MonoGraph System User's Manual and Installation
               Instructions.  
          
ERRORS.TXT   - This text file lists the MGDIAG.EXE error codes
               and their meanings.

MODEKEY.EXE  - This program is a memory-resident utility that
               allows you to alternate between the two MonoGraph
               display modes, high resolution 1024 x 1024 and CGA
               emulator mode.

               To install the utility, type MGKEY at the DOS
               prompt, followed by the 'Enter' or 'Return' key. 
               To use the utility, press the 'Alt' and 'Esc' keys
               simultaneously.  This key sequence enables you to
               toggle between the two display modes.

ID.EXE       - This utility returns the firmware version number
               and several hardware configuration parameters for
               your MonoGraph graphics controller.
     
CURSOR.EXE   - On some IBM PC compatible systems, the ROM BIOS
               implementation conflicts with the MonoGraph during
               the initial boot sequence.  The result is either a
               static cursor or a missing cursor at the DOS
               prompt.  The CURSOR.EXE utility can be used to
               restore a blinking cursor each time your system is
               booted.  Type INSTALL.BAT to install this utility.

INSTALL.BAT  - This utility copies the CURSOR.EXE utility to your
               boot disk and updates your AUTOEXEC.BAT file.

CURSOR.DAT   - This file is used by CURSOR.BAT to install the
               CURSOR.EXE utility.

BATUTIL.EXE  - This program is used by CURSOR.BAT to install the
               CURSOR.EXE utility.