This directory contains a version of the drivers that are required
for the HP OmniBook 600 PCMCIA support.  These drivers include a
modified PCCARD.VXD, the HP Socket Services driver, and installation
inf, (OB600SS.VXD and OB600SS.INF).

The following instructions should be used to setup the protect mode
PC Card (PCMCIA) support for the HP OmniBook 600C:

1) Copy PCCARD.VXD, OB600SS.INF, and OB600SS.VXD to a floppy disk.
2) Boot Win'95
3) Open the system properties page (click right mouse button on
   My Computer and then select properties is the quickest way).
4) Select the Device Manager.
5) Open the Other devices section.
6) Look at the properties for each Unknown Device to locate the
   one with resources "Interrupt Request 09" and "Input/Output
   Range 00EC-00ED".  This is the socket controller device.
7) Select the Driver property page.  It should say that no driver is
   installed.  Click the Change Driver button.
8) In the "Select Hardware Type" box select PCMCIA socket and click OK.
9) In the "Select Device" box click have disk.
10) The "Install From Disk" box should show "Copy manufacturer's files
    from: A:\.  Put the floppy in drive A: and press OK.
11) The Select Device box should now list "HP OmniBook 600 PCMCIA
    controller".  Select it and click OK.
12) You should now be back in the device Properties page with a number
    of drivers listed (including ob600ss.vxd).  Click OK.
13) Win'95 will now start copying files.  It will ask for one of the
    Win'95 disks.  If you have that disk on floppy insert it now.
    If you installed from CD or from the retail directory installed
    from your hard disk click OK.  You will then get another dialogue
    box which allows you to change the source for copy files from.
    Make the necessary change and click OK.
14) After Win'95 completes copying the files you are returned to the
    properties page.  Click OK.
15) You will get a "System Settings Change...do you want to restart your
    computer now?" dialog.  Click YES.
16) System restart...wait patiently.
17) Reopen the System Properties Device Manager page.  You should now
    see the HP OmniBook 600 PCMCIA controller with either a red splot
    or a yellow splot.  Select it and open it's properties page.
18) Clear the active configuration check boxes and click OK.
19) Reopen the properties page and check the active configurations check
    boxes and click OK.
20) You should then see the Welcome to the PC Card (PCMCIA) Wizard dialog.
    Click next.  (Note: make sure to set the No Yes selections correctly
    first.)
21) The next dialog gives you a chance to review the changes it is about
    to make to config.sys, autoexec.bat, and system.ini.  You may click
    the Yes check box if you want to review or make changes to the
    drivers that are being commented out.  Otherwise click No.
22) Next is the finished box.  Click Finish.
23) Next you get another reboot box.  Click Yes.
24) Press ctrl-alt-del when it says you can safely turn off the computer.
25) System restart...wait patiently.
26) Congratulations you have installed the protected mode PC Card drivers,
    but you still need to make one more change if you are running 
    OBMGM.COM (check your config.sys file).  If you are then you
    will need to add a line for OBMGM.COM in the IOS.INI file
    in you Windows 95 directory and reboot.  This is necessary to 
    get ATA and SCSI PC Cards to work properly.