VGRAF Graphic File Viewer  VERSION 1.04
Copyright (c) 1992 ATI Technologies Inc.  All Rights Reserved.

Keyboard Commands:
-----------------
  F1    = Help (this screen)
  F2    = Choose specific viewing mode
  F3    = Change directory
  ESC   = Exit to DOS
  Enter = View selected graphic file (highlighted)

Description:
-----------
VGRAF is used to  view  graphic  files  on  the ATI mach8 and mach32
based video adapters. TARGA  (tm)  and  Autodesk  Animator FLI and FLC
formats are supported.

TARGA files in  8,  16  and 24 bit formats can be viewed. This program
exploits  deep  color  modes  on  the  mach32. The TARGA files may be
Color-Mapped, True Color, uncompressed or RLE compressed. When viewing
files on the mach8, only an 8-bit display mode is available.

The optimal display resolution  and  best pixel depth is automatically
selected upon  requesting  a  file  be  viewed using the Enter key. To
explicitly set a viewing  mode,  press  the F2 key to call up the mode
selection menu. Make a choice from this menu, and then press the Enter
key to view the file at  the  specified resolution. After the image is
displayed  (a  beep  occurs  when  this  is completed), these keyboard
functions are active:

  Up         = Pan up
  Down       = Pan down
  Left       = Pan left
  Right      = Pan right
  PgDn       = Pan 1/3 screen down
  PgUp       = Pan 1/3 screen up
  Ctrl+Left  = Pan 1/3 screen to left
  Ctrl+Right = Pan 1/3 screen to right
  Esc        = Return to file selecton menu

Image panning is available only  when the selected image resolution is
larger than the viewing mode resolution.

Autodesk Animator FLI or  FLC files  may also be viewed. The animation
is run in 640x480 mode, with the image centered on the screen if it is
smaller. The animation selected repeats automatically. While a FLI or
FLC file is being viewed, the following keyboard functions are active:

  +          = Increases the  frame  rate  if  the Frame speed control
               (F9) is toggled on
  -          = Slows the frame  rate  if  the Frame speed control (F9)
               is toggled on
  F8         = Resets the frame rate value altered by the + and - keys
  F9         = Frame speed control (toggles on and off);  when toggled
               on (the default),  the frame speed delay value is used;
               when toggled off, this value is ignored
  F10        = Single frame step mode (toggles on and off) - the SPACE
               bar advances the frame when this mode is on
  Esc        = Return to file selection menu

Press the Esc key to return to the file menu selection.

For command line options, type "VGRAF help" at the DOS prompt.