To Install First Time OS/2 For Windows From Dolphin 8000AT CD-ROM Drive
=======================================================================

1.  Duplicate a copy of "IBM OS/2 2.1 Diskette 1" into a new 1.44M floppy
    diskette and label it "Dolphin Diskette 1";

2.  Copy the Dolphin 8000AT CD-ROM driver (DOLAT001.ADD) from the "Dolphin
    8000AT CD-ROM Device Driver For OS/2" provided by Optics Storage into
    "Dolphin Diskette 1";

3.  Add the following statements into the CONFIG.SYS file in "Dolphin
    Diskette 1":

         BASEDEV=DOLAT001.ADD /P:XXX /V


    /P:XXX  =  XXX represents the address port in three figures. e.g. 340.
    /V      =  Verbose mode


4.  Connect up Dolphin 8000AT CD-ROM drive, make sure the jumper setting for
    the port address is correspond to the statement mentioned in 3.

5.  Boot up the PC up using "IBM OS/2 2.1 Installation Diskette". When the
    installation program requests for "IBM OS/2 2.1 Diskette 1", insert
    "Dolphin Diskette 1" instead. Then put in the OS/2 CD-ROM into Dolphin
    CD-ROM drive and continue to follow the standard installation instructions.


NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.

THE ABOVE PROCEDURES ARE JUST FOR YOU TO INSTALL OS/2 FROM DOLPHIN 8000AT
CD-ROM DRIVE. THE DRIVE ITSELF IS NOT YET PROPERLY INSTALLED UNDER OS/2.
TO PROPERLY INSTALL THE DRIVE UNDER OS/2, PLEASE REFER TO THE MANUAL INCLUDED:

             .----------------------------------------------.
             |   8000 AT DOLPHIN CD-ROM DRIVE               |\
             |   INSTALLATION SHEET                         | |
             |   PRE-RELEASE REVISION OF OS/2 DEVICE DRIVER | |
             |   (OCTOBER 17, 1994)                         | |
             '.---------------------------------------------'.|
               `----------------------------------------------'

NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.NB.

(CVM Oct-1994)