Content of Software diskette:       Revised: September 27, 1996

CDR_F127.EXE -- HP 4020i CD-Writer Firmware Upgrade Utility.
README.TXT -- This document (English)
LEAME.TXT -- This document (Spanish)
LEGGIMI.TXT -- This document (Italian)
LIESMICH.TXT -- This document (German)
LISEZMOI.TXT -- This document (French)

===============================================================

ENSURE THE FOLLOWING BEFORE ATTEMPTING THE FIRMWARE UPGRADE: 


1) Close down any open applications.
2) Remove any CDs from the CD-Writer drive.
3) Verify that your SCSI host adapter is properly configured and
   is operating.

WARNING: Once the upgrade is running Do not turn the power
         off to your computer until the upgrade operation is 
         complete. Failure to comply could result in an 
         unusable drive.

===============================================================

The HP SureStore CD-Writer firmware upgrade utility 
(CDR_F127.EXE) is a WINDOWS program that can be run from
Windows 95 or Windows 3.xx.  

This program will not run from DOS or Windows NT.

===============================================================

Windows 3.x

   1. Ensure the CD-Writer is connected to a SCSI Host Adapter, 
      your ASPI Manager is loaded, and the CD-Writer is properly 
      identified upon the boot of your computer.   
   2. Start Windows.
   3. From Program Manager select File, then Run and type in the
      program name (example:  a:\cdr_f127.exe) and press Enter.
   4. Follow the on-screen instructions. 
   5. Wait for the on-screen counter to count down to zero, and 
      for all LEDs on the CD-Writer to stop flashing.
   6. Exit Windows and Reboot the system.

Your CD-Writer should now be upgraded to the latest firmware! 

===============================================================

Windows 95

   1. Close all applications except Explorer.
   2. Select "START" on the Taskbar and then "RUN".
   3. Type in the path to the firmware upgrade program.
      (example:  a:\cdr_f127.exe)
   4. Follow the on-screen instructions.
   5. Wait for the on-screen counter to count down to zero, and 
      for all LEDs on the CD-Writer to stop flashing.
   6. Reboot the system when told to do so.

Your CD-Writer should now be upgraded to the latest firmware! 
        
===============================================================

Troubleshooting
---------------

   If the firmware upgrade utility has not completed after 10 minutes, 
   or the red and orange LEDs are still active after 10 minutes, the 
   upgrade has failed.      

   If the firmware upgrade program fails, or if you experience a power 
   outage during the upgrade, shut-down your computer and attempt the  
   upgrade again.

   If the second firmware upgrade fails, contact Customer      
   Support at (970) 635-1575.