Mar. 1994

		3Com 3+ Share Driver Installation
			       for
	       D-Link DE-650 PCMCIA Ethernet Adapter
	      =======================================


The D-Link 3COM 3+ Share Driver Program lets you run 3Com 3+ Share
on your PC with the D-Link DE-650 PCMCIA Ethernet Adapter.

The following files will be used in this installation:

Files		 Contents
-----------	 -------------------------
NEC65PD.SYS	 DE-650 Driver Program
ETH.SYS 	 3Com 3+ Share Driver


1. Follow the installation procedure for 3Com EtherLink board.

2. Copy the program ETH.SYS from the Installation Diskette for
   the D-Link DE-650 PCMCIA Ethernet Adapter to the boot disk/diskette.
   This program will replace the program of the same file name
   (ETH.SYS) when you perform the installation procedure in step 1
   above.


3. In the CONFIG.SYS file on the boot disk/diskette, make sure
   you have the following statements.  The order of these
   statements must be as shown below.

      *** PC installed Socket service or Databook Cardtalk***
  DEVICE = NCD.EXE
  DEVICE = NEC65PD.SYS [-d] [-w] <sw_int> <irq> <io_addr> <m_base>
  DEVICE = ETH.SYS

  Please refer to \NECPC\INSTALL\README.DOC or \NECPC\install.doc for more detail
  information.

You may now boot and start your 3COM workstation.

Notes:
1. Parameters for NEC65PD.SYS
[-d]		Delay Initial - The driver program will not initialize
		the network interface card until the packet driver program
		is accessed by its upper layer program first time.
[-w]		the -w parameter is for use with the Windows environment only.
<sw_int>	is the software interrupt vector number used by the packet
		driver program, which can be from 96 to 128.
<irq>		is the hardware interrupt (IRQ) line set on your network
		interface card. The default is 5 if this parameter is not
		specified.
<io_addr>	is base I/O address set on your network interface card.
		The default address of 0x300 is used, if this parameter
		is not specified.
<m_base>	is attribute memory base. The default value is 0xd000.


2. Parameters for INSTALL utility:
NCD.EXE
    NCD.EXE is an open adapter utility.
    NCD.EXE supports INEC 9821 notebook.

   device=ncd.exe [/iop:P0] [/mem:P1] [/irq:P2] [/slt:P3]

   Parameter description:
	/iop   :I/O base
	/mem   :Attribute memory base
	/irq   :IRQ value
	/slt   :Slot type, default value is 0x0 for slot 1.

	P0 :The selectable window I/O base with 0x20 range.
	    The default value is 0x300.
	P1 :The selectable window memory base.
	    The default value is 0xd000.
	P2 :The selectable irq value.
	    The default value is 0x5.
	P3 :The selectable slot number.
	    The default value is 0x0