Release Notes
=============

1. Using the Windows SETUP Program to Change Drivers
   =================================================
   If you use the Windows SETUP program to switch among drivers
   (either in Windows or from the DOS command line), always elect
   to use the CURRENT installed driver unless you have a new
   Windows driver diskette. If you need to re-install the original
   drivers included with the your board, run the WinSetup program on
   the diskette included with your display card.

2. Installation of DOS Drivers under Windows
   =========================================
   To install DOS drivers from the Windows Program Manager or File
   Manager, either click on the SETUP.PIF file or open a DOS session
   and then run SETUP.EXE.