Driver Installation Guide for Lantastic/AI
	   ================================================

Introduction
============
    This document describes the procedure to setup driver on LANtastic/AI
    operating system for PN-16 Series Ethernet Adapter.


Installation Procedures
=======================

 A. To install Lantastic/AI v4.0 or v5.0 software on a station:

    1. Run your existing DOS system as you usually do.

    2. Place the Lantastic/AI Network Operating System Disk #1 in
       floppy drive A: or B:

    3. Change to the drive containing the diskette and type
       "INSATLL <Enter>" at the system prompt.

    4. Choose NE2000 as your Ethernet Hardware Adapter.

    5. Follow all the operations as you are prompted on the screen.

    6. After installing the Netware Operating System, reboot your system.


    --- Sample AUTOEXEC.BAT file ---

	   :
	call C:\LANTASTI\STARTNET.BAT
	   :


    --- Sample STARTNET.BAT file for Lantastic/AI v4.0 ---

	   :
	@ECHO OFF
	PATH C:\LANTASTI;%PATH%
	SHARE /L:200

	NEX000 IRQ=3 IOBASE=300 16-BIT VERBOSE
	AILANBIO
	REDIR ADMIN LOGINS=3
	SERVER C:\LANTASTI.NET

	NET LOGIN/WAIT \\ADMIN ADMIN
	NET LPT TIMEOUT 10
	   :


    --- Sample STARTNET.BAT file for Lantastic/AI v5.0 ---

	   :
	@ECHO OFF
	SET LAN_DIR=C:\LANTASTI.NET
	SET LAN_CFG=C:\LANTASTI
	PATH C:\LANTASTI;%PATH%

	SHARE /L:200

	NEX000 IRQ=3 IOBASE=300 16-BIT VERBOSE
	AILANBIO
	REDIR ADMIN LOGINS=3
	SERVER C:\LANTASTI.NET

	NET LOGIN/WAIT \\ADMIN ADMIN
	NET LPT TIMEOUT 10
	NET POSTBOX
	   :


 B. To install Artisoft LANtastic v6.0 LAN software on a workstation:

    You can install LANtastic on computers that are running DOS only, or on
    computers that are using both DOS and Windows. LANtastic v6.0 includes
    both DOS- and Windows-cased interfaces.

    If you run the command "INSTALL" under Windows, both the DOS and Windows
    interface will be installed on the computer. If Windows isn't running,
    only the DOS interface will be installed.

    1. Run your existing DOS (or Windows) system as you usually do.

    2. Place the first LANtastic diskette in floppy drive A: or B:

    3. Run the LANtastic INSTALL programe.

       a. If you are installing from the DOS prompt, type:

	       A: INSTALL <Enter> or B: INSTALL <Enter>

       b. If you are starting from Windows. Form Windows Program Manager
	  or the File Manager windows, select the File menu and choose
	  RUN. In the RUN window, type:

	       A: INSTALL <Enter> or B: INSTALL <Enter>

	  then choose OK.

    4. Proceed throught the installation screens, following the instruction
       on each. Choose OK or press Enter to continue from each screen.

    5. In the Select Network Adapter window select NE2000 adapter as your
       Ethernet Hardware Adapter.

    6. Follow all the operations as you are prompted on the screen.

    7. When the installation is complete, INSATLL automatic reboot your
       computer.